How much can you skim off the top of a

Need technical Q/A then you're in the right place

Moderator: martauto

ed325i
E30 Zone Addict
E30 Zone Addict
Posts: 4146
Joined: Mon Jan 10, 2005 11:00 pm

Post Fri Jan 26, 2007 7:15 pm

2.5 m20 block ?
stonesie
E30 Zone Addict
E30 Zone Addict
Posts: 3277
Joined: Sat Jan 07, 2006 11:00 pm
Location: Doncaster

Post Fri Jan 26, 2007 8:00 pm

All depends what you want to do with it, for a general rebuild as little as possible to get it flat (a few thou).

But for a 2.7 conversion i think its a couple of mm depending what head, rods, crank and pistons you use.



how long is a piece of string again? winkeye
ed325i
E30 Zone Addict
E30 Zone Addict
Posts: 4146
Joined: Mon Jan 10, 2005 11:00 pm

Post Fri Jan 26, 2007 9:23 pm

I havent measured it yet but is there a max that can be taken off ?

Image
DanThe
E30 Zone Team Member
E30 Zone Team Member
Posts: 28649
Joined: Sat Sep 10, 2005 11:00 pm
Location: Staffs

Post Fri Jan 26, 2007 10:42 pm

Whats the standard loss for a 2.7 conversion then?
Simon13
The longest resto in the world !
Posts: 22697
Joined: Mon Jan 10, 2005 11:00 pm
Location: Camberley, Surrey don't u know

Post Fri Jan 26, 2007 11:46 pm

there is no standard measurement really, on average it's about 3mm

I'm not sure how much you can take off either, as long as valves and pistons do not hit and it can be timed up properly then who knows!
ed325i
E30 Zone Addict
E30 Zone Addict
Posts: 4146
Joined: Mon Jan 10, 2005 11:00 pm

Post Sat Jan 27, 2007 9:28 am

So there are no water/oil ways that can be broken into ?