320: to be, or not to be? this is my question..

General E30 related discussions -
Please put technical questions in E30 Tech Help forum below

Moderator: martauto

User avatar
bigdirtyturbo
E30 Zone Newbie
E30 Zone Newbie
Posts: 3
Joined: Fri Jan 19, 2007 11:00 pm

Post Tue Jan 23, 2007 11:05 pm

ive been offered a decent looking 320 ( manual) on a G plate for very little money (150 quid with 6 months mot), Apparently the big ends have gone and its knocking after revving past 1700k. ( is this common, or is it usually main bearings? )
I was thinking of buying this car, fixing said problem and upgrading the engine to a bigger one at a later date..
Now.. after reading another recent thread alot of you advise to give the 320 a miss for various reasons. are they really that bad?? I also noticed that its said that the 325 engine gives better mpg, this is important to me as i do a fair few miles. So with this in mind what engine would be the best to fit? 2.5 , 3.0 , 3.5, 12v, 24v ?? any ideas of MPG's??
any advice would be much appreciated as im wanting to get back into BMW ownership but dont want to waste my money on a pointless project.
cheers, dave.
Speedtouch
Old Skooler
Old Skooler
Posts: 14130
Joined: Tue Feb 14, 2006 11:00 pm
Location: Canterbury

Post Tue Jan 23, 2007 11:15 pm

Hi bdt, welcome to the Zone! I'd say it's an unusual fault for a 320i to have worn big ends - maybe it's something else? mind you, you are expecting it to rev a little high :wink: It could well be worth fixing up if the rest of the car is in good shape. The 2.5's are far livelier and you can get good mpg - 30+ average if you're carefull, but the 2.0 is a very smooth engine, some have compared it to a Jag V12. Their main snag is a lack of low-end torque, so you have to rev them that much more to maintain progress.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
User avatar
bigdirtyturbo
E30 Zone Newbie
E30 Zone Newbie
Posts: 3
Joined: Fri Jan 19, 2007 11:00 pm

Post Tue Jan 23, 2007 11:28 pm

LOL, 1700rpm!! 30mpg sounds good to me, shoud i look to stay 12v or move forward with a 24v engine. Is it a simple remove old lump and drop in nice new 2.5 engine and ECU procedure ? wish the 2.0 had the v12 power as well winkeye
snoops
Major Helmet
Posts: 2828
Joined: Fri Nov 03, 2006 11:00 pm
Location: Time running out for me on the Zone

Post Wed Jan 24, 2007 11:11 am

either a 2.5 or you could build a 2.7 with eta bottom end n ull have bags of torque and still good economy
User avatar
bigdirtyturbo
E30 Zone Newbie
E30 Zone Newbie
Posts: 3
Joined: Fri Jan 19, 2007 11:00 pm

Post Wed Jan 24, 2007 5:32 pm

what is eta?? seen it mentioned a few times now. what kind of mpg are people getting from the 2.7. is there a significant power/torque increase over the 2.5??