tapping into the loom neatly for megasquirt?

Need technical Q/A then you're in the right place

Moderator: martauto

liam012
E30 Zone Camper
E30 Zone Camper
Posts: 1424
Joined: Sun Aug 28, 2005 11:00 pm

Post Mon Jan 22, 2007 2:50 pm

Whats the neatest option for taping into the loom for megasquirt?
interested to know what other people have done regarding scotch locks, leccy tape and bubble gum. :)
i will be running of stock cps / coil - the stock cps is a 3 core wire so it seems there is no nice way of tapping into this? ideally i'dd like to make splits in under the dashboard or is it all to fiddly working that close to the plug
l
because of the pinking i am having to install sooner than expected - am i a bit ambitious in thinking i can start on friday and have a smooth enough map to get to work on monday? (i have a wideband and controller) or is that way too ambitious.

interested to hear thoughts and suggestions ,
ta
Image
charlE30
E30 Zone Addict
E30 Zone Addict
Posts: 3818
Joined: Mon Jan 10, 2005 11:00 pm
Location: Warwick

Post Mon Jan 22, 2007 5:08 pm

I wouldn't use scotch locks mate, do it properly and solder all joints then cover with heatshrink tube, you can even get brush on tape :mad: http://www.frost.co.uk/productList.asp? ... Cat=Wiring

I'm extending the loom to my ECU on my M30 conversion and it's got three shielded 3 core wires which are proving to be a right **** to do.. well nicely anyway.

I've got no idea about the MS though :roll:

Good luck
BMW E30 344i track car :banana:
BMW F31 335d xdrive
Ant
Retired Team Member
Retired Team Member
Posts: 10496
Joined: Tue Dec 21, 2004 11:00 pm
Location: PD+E dept :D

Post Mon Jan 22, 2007 5:16 pm

Laim, tap into the stock loom about 6" from the motronic connector, leaves all the joints insode the car and keeps the bay looking stock

use the AFM loom and tap into that for the IAT, you can pop the rubber boot back on the stock connector and solder the new IAT pigtail into that area and again cover the new connection with the existing boot.

Word of warning, power the MS up and make sure you have comms with the laptop before you go too in depth, no comms is the worst issue you may come accross.

:thumb:
Product Development and Endurance for Delphi.

Original performance chips, original works not unlicensed copies :D Email FTW