obc tec 1 sport

Need technical Q/A then you're in the right place

Moderator: martauto

jamesh1977
BEWARE Zone Thief
Posts: 458
Joined: Thu Apr 27, 2006 11:00 pm
Location: central scotland

Post Tue Jan 16, 2007 6:32 pm

went to fit my obc into my tec 1 sport got the control box gong the display its all plugged into the dash clocks took the panel off behind the glove box to plug it into the conections behind there and there was nothing to plug it into... can anyone tell me if i need a diffrent loom or if theres a way of plugging it in or am i chasing a lost couse ? its lighting up and giving me temp readings and nothing else bar lines but where does the other plugs go to and what are they for? i know the ones for the outside temp and alarm horn and i know the green wires are for the imobiliser but no where to plug it in then theres the earth which is easy but then theres 2 red wires on one plug where will i put that ?
Image
User avatar
orangecurry
E30 Zone Addict
E30 Zone Addict
Posts: 2518
Joined: Mon Apr 11, 2005 11:00 pm
Location: West Sussex

Post Tue Jan 16, 2007 7:50 pm

the main connector is the yellow plug into the yellow socket at the back of the cluster - this feeds the OBC power and info. I don't think you need anything else. Obviously if you wan't temp readings the separate temp loom and sensor need to be attached.

Read the manual on using the OBC - you probably just need to set the time/date, and wait for the OBC to work out MPG and fuel remaining in the tank...