idling too high
Moderator: martauto
-
win
- E30 Zone Newbie

- Posts: 87
- Joined: Sun May 28, 2006 11:00 pm
- Location: north london
my car seems to be idling a bit too high its now idling at about 900 rpm when it should be 760 + or - 50rpm according to Haynes manual. i had co adjusted a few months back and also tuned and it was fine but since i adjusted the valve clearances and cleaned out hrottle body its been running a bit high. Its a 325,and my question is can i turn the revs down myself or will the CO need adjusting again?
Cheers
Win
Cheers
Win
-
georob
- E30 Zone Camper

- Posts: 1106
- Joined: Thu Feb 03, 2005 11:00 pm
- Location: Aberdeenshire
Sure theres an idle adjustment screw on the tb
-
win
- E30 Zone Newbie

- Posts: 87
- Joined: Sun May 28, 2006 11:00 pm
- Location: north london
Cheers mate, i did see the adjusting screw but i was just making sure it would'nt affect the CO level.
Win
Win
-
buster
- E30 Zone Addict

- Posts: 3779
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Near middlesbrough,Teesside
do not touch that !!! Its not for idle adjustment.The ICV does that.The threaded bar is just there for a base setting and should never be used for controlling idle speed.Check your tps switch is ok.georob wrote:Sure theres an idle adjustment screw on the tb
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
DON'T TOUCH THE SCREW!
-
georob
- E30 Zone Camper

- Posts: 1106
- Joined: Thu Feb 03, 2005 11:00 pm
- Location: Aberdeenshire
Whats that screw for?
-
Morat
- E30 Zone Team Member

- Posts: 8943
- Joined: Thu Feb 09, 2006 11:00 pm
- Location: The Peoples Republic of Yorkshire
not for touching
Brian has spoken!
Brian has spoken!
E30 Touring 0.35 cD - more slippery than prison soap 

Praise the Lard... and pass the dripping!

Praise the Lard... and pass the dripping!
-
bobafett
- E30 Zone Regular

- Posts: 285
- Joined: Tue Dec 12, 2006 11:00 pm
- Location: Bristol
It opens a black whole, the world will end and it will be your fault !georob wrote:Whats that screw for?
DON'T TOUCH IT !
What ?! Drive straight officer......It's an E30 !
It's the Ultimate Drifting Machine.
It's the Ultimate Drifting Machine.
-
eltel
- E30 Zone Regular

- Posts: 654
- Joined: Wed Nov 09, 2005 11:00 pm
- Location: mid wales
if you've already foolishly 'touched' the screw what will happen and how can i reset it back to what it was??
adjusted it that many times cant remember where it originally was!
adjusted it that many times cant remember where it originally was!
Only in the good lord we trust.. In everything else we check!!
1988 325i Tourer, Lowered, Deep Dish Alloys, Obc, Cruise Control, Heated Leather Sport Seats....
1988 325i Tourer, Lowered, Deep Dish Alloys, Obc, Cruise Control, Heated Leather Sport Seats....
-
rj
- E30 Zone Newbie

- Posts: 177
- Joined: Fri Dec 01, 2006 11:00 pm
The throttle stop screw is factory set to ensure the throttle butterfly just allows a slight amount of air through the throttle housing. If you have moved it it's not so disasterous. Simply unscrew it until it no longer touches the lever. Then feeling with your fingers against the end of the screw and lever check when it just begins to move the lever. When that is established, give it a further quarter turn and refit the anti tamper cap.
This sets the butterfly at it's minimal position. The ICV then controls the idle speed.
It is then however important to ensure that the throttle position switch is adjusted correctly to the newly adjusted throttle stop screw.
This sets the butterfly at it's minimal position. The ICV then controls the idle speed.
It is then however important to ensure that the throttle position switch is adjusted correctly to the newly adjusted throttle stop screw.
-
win
- E30 Zone Newbie

- Posts: 87
- Joined: Sun May 28, 2006 11:00 pm
- Location: north london
How do you adjust the throttle position switch?
-
rj
- E30 Zone Newbie

- Posts: 177
- Joined: Fri Dec 01, 2006 11:00 pm
I've got a pdf file which explains how to check, clean and align it. The file is too large to attach through the forum but I can send it to your email address if you like.
-
eltel
- E30 Zone Regular

- Posts: 654
- Joined: Wed Nov 09, 2005 11:00 pm
- Location: mid wales
please could you send that file to me also...garethearp@fsmail.net.....thankyou
Only in the good lord we trust.. In everything else we check!!
1988 325i Tourer, Lowered, Deep Dish Alloys, Obc, Cruise Control, Heated Leather Sport Seats....
1988 325i Tourer, Lowered, Deep Dish Alloys, Obc, Cruise Control, Heated Leather Sport Seats....
-
JazzMan
- E30 Zone Camper

- Posts: 1070
- Joined: Sat Mar 26, 2005 11:00 pm
- Location: Deep South
could you send that to me as well please patrick AT msportster.co.uk 

