TB question? 2.7 eta vs 2.5?

Need technical Q/A then you're in the right place

Moderator: martauto

320Touring
E30 Zone Team Member
E30 Zone Team Member
Posts: 12316
Joined: Fri Feb 11, 2005 11:00 pm
Location: Glasgow (Scotland)

Post Fri Jan 12, 2007 5:32 pm

I've got a notion to fit a bigger TB to the old m20b20, and was going to go down the 2.5 route.

however I have a 2.7 manifold with the TB attached in the house.

would it be better than the 2.5?

whats the diameters involved?

thanks!

Neil
The big Unit Parts Clear out Make me an offer on parts!
http://www.e30zone.net/modules.php?name ... 81#2766881
User avatar
exup
Boost Junkie
Posts: 351
Joined: Tue Mar 08, 2005 11:00 pm

Post Fri Jan 12, 2007 6:23 pm

If it came off a 525e eta , then it will be no good at all as theres much smaller than the 2.5 and the ports are are smaller than the std 2.l manifold cause there round in shape
Andyboy
Alpina Colada
Posts: 12577
Joined: Mon Sep 11, 2006 11:00 pm
Location: Notts

Post Fri Jan 12, 2007 10:15 pm

What you do is this............

Take your inlet manifold off. Place the 325i inlet gaskets on your 320i head, stuff rag down the inlet ports and open up the 320i ports to 325i size with a dremmel. It's only the top corners of the ports you need to do - about 3-4 mins per port, it's that easy. Then fit the 325i inlet manifold with throttle body but swap the 320i injectors over as the 325i ones are too much for it. I'll post some pics up of the ports.

Oh, you'll need a chip in the ECU. Jayson (Chippeduk) did me one and it was good. These two mods really do liven up the 320i, especially top end.

2.7 Eta inlet ports are a lot smaller than the 320i ones. The Eta TB is the same as the 320i anyway.
320Touring
E30 Zone Team Member
E30 Zone Team Member
Posts: 12316
Joined: Fri Feb 11, 2005 11:00 pm
Location: Glasgow (Scotland)

Post Mon Jan 15, 2007 4:10 pm

Andyboy wrote:What you do is this............

Take your inlet manifold off. Place the 325i inlet gaskets on your 320i head, stuff rag down the inlet ports and open up the 320i ports to 325i size with a dremmel. It's only the top corners of the ports you need to do - about 3-4 mins per port, it's that easy. Then fit the 325i inlet manifold with throttle body but swap the 320i injectors over as the 325i ones are too much for it. I'll post some pics up of the ports.

Oh, you'll need a chip in the ECU. Jayson (*plug*) did me one and it was good. These two mods really do liven up the 320i, especially top end.

2.7 Eta inlet ports are a lot smaller than the 320i ones. The Eta TB is the same as the 320i anyway.
thank you sir :D :cool:

*gets ready to use dremmel in anger*
The big Unit Parts Clear out Make me an offer on parts!
http://www.e30zone.net/modules.php?name ... 81#2766881