please lock, now going in engine swaps section. thanks

Need technical Q/A then you're in the right place

Moderator: martauto

tomson
E30 Zone Addict
E30 Zone Addict
Posts: 3598
Joined: Sun Nov 06, 2005 11:00 pm
Location: Bristol

Post Sun Jan 14, 2007 12:11 pm

Last edited by tomson on Sun Jan 14, 2007 1:48 pm, edited 2 times in total.
Wilson325i
E30 Zone Camper
E30 Zone Camper
Posts: 1184
Joined: Sun Jan 09, 2005 11:00 pm
Location: Here in SE

Post Sun Jan 14, 2007 12:20 pm

*i stand to be corrected*

the most important is the, shells, bearings,oil pump (a must if doing a bottom end) piston rings and go over the rest like have a look at the crank what state it is in, but if there was anything wrong with it in the first place you would have known about it, same as the pistons LOL.
Speedtouch
Old Skooler
Old Skooler
Posts: 14130
Joined: Tue Feb 14, 2006 11:00 pm
Location: Canterbury

Post Sun Jan 14, 2007 12:24 pm

Gasket set is pretty important! :) Maybe some Blue Hylomar too...
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
tomson
E30 Zone Addict
E30 Zone Addict
Posts: 3598
Joined: Sun Nov 06, 2005 11:00 pm
Location: Bristol

Post Sun Jan 14, 2007 12:26 pm

Wilson325i wrote:*i stand to be corrected*

the most important is the, shells, bearings,oil pump (a must if doing a bottom end) piston rings and go over the rest like have a look at the crank what state it is in, but if there was anything wrong with it in the first place you would have known about it, same as the pistons LOL.
Thats what i basically have on the list, just making sure ive not missed anything!