Hello!
Don't suppose anyone's got a map for an Emerald M3D that's been written for a 325i by any chance?
Mine came programmed with a VR6 turbo map but I've gotta put 500 miles on the engine before they can map it so I reckon it'd be better to have a map for the engine than something that might be miles out.
Cheers!
Alex
Emerald Maps for the 325i
Moderator: martauto
-
Turbo-Brown
- Boost Junkie
- Posts: 4705
- Joined: Tue Feb 15, 2005 11:00 pm
- Location: Aldershot, Hants
)-
Ant
- Retired Team Member
- Posts: 10496
- Joined: Tue Dec 21, 2004 11:00 pm
- Location: PD+E dept :D
why not run her in on motronic dude ?, I think Andy wired his emerald so he could swop between the two, ie he drove to the mapping session on stock ECU, swopped a few plugs over in the engine bay , then in she went for the mapping session on the base map.
best soloution I could come up with, swung the MS for me too being able to Diy it and having a good base map available.
I'm at a similar transition stage, which to fit first, gotta be the MS, the rest is nuts and bolts
best soloution I could come up with, swung the MS for me too being able to Diy it and having a good base map available.
I'm at a similar transition stage, which to fit first, gotta be the MS, the rest is nuts and bolts
Product Development and Endurance for Delphi.
Original performance chips, original works not unlicensed copies
Email FTW
Original performance chips, original works not unlicensed copies
Email FTW-
Turbo-Brown
- Boost Junkie
- Posts: 4705
- Joined: Tue Feb 15, 2005 11:00 pm
- Location: Aldershot, Hants
Mmm that's not a bad idea, but because of the turbos, throttle bodies and associated gubbins, there's nowhere for the AFM to go and I'd really not be happy about running a turbocharged motor on N/A management.
I figure though that if I can get a 325 map and then add the boost map from the VR6 thing to that then it'll be a reasonable starting point.
Tis actually quite easy to do, if you convert the *.fig files of Emerald into a *.txt file, you can open them in notebook and then just cut and paste bits in from different maps
I figure though that if I can get a 325 map and then add the boost map from the VR6 thing to that then it'll be a reasonable starting point.
Tis actually quite easy to do, if you convert the *.fig files of Emerald into a *.txt file, you can open them in notebook and then just cut and paste bits in from different maps