Good points Martinaston!
Changed the thermostat today, which took much longer than it should have done because I didn't think to make a note of how the old one was installed and made a best guess which was to put the O ring in first, and then the thermostat. This lead to a steady drip from the thermostat housing when the engine was on. Doh. Took it apart again and put the thermostat in first, with the O ring after that and it made a lot more sense. Anyway, the engine seems to run a little warmer on the gauge, and gets up to the lower white line easily at idle instead of hovering just above the blue.
Also, some cack-handed dickhead (Morat holds up cacky hands) over tightened the bottom 10mm bolt and did something nasty to the thread on the housing so its now a real pain to get the bottom bolt to grip. Luckily the whole affair seems to be water tight, I'll check again with the system really hot and pressurised but I don't really want to drive the car too hard till its fixed.
I managed to get some airlocks in the system but once I'd bled it and got the heater to blow hot air again I had a minor brain wave and remembered that the roads nearby are on a sort of grid, so you can drive uphill 200m, then downhill 200m with 3 nice speed humps per 200m section. This seemed to shake out the last of the airbubbles a treat

The good news is that when I was doing the radiator flush step from the technical article the water came out clear as...er... water straight away. So it seems I can trust the garage that did it last time to do a decent job.
Lets see how they do with the HT leads. I'm not feeling up to that one myself.
OH, and a 6mm socket is far superior to a 4mm flat head screw driver for undoing hose clips. So remember folks, six better than four

(except when its only firing on five

)
I tried sticking my hand over the filler cap hole to see if the idle was improved, but either Martinaston has asbestos hands or I'm more delicate than I thought - it was a bit hot to leave my hand on there for more than about 10s but it did seem to make a marginal improvement if I really jammed it down. So.. a new oil filler cap is going on my list.
thanks for all the help folks!
Morat