Hi All,
I bought a Power Chip for my 318iS off Ebay. When I installed it the car started but idled rought at about 600rpm. I took the car for a run in order to allow the chip to 'learn' the settings. The car was really flat and unresponsive upto about 3000rpm where she took off. If I let the revs drop below 3000 she was unresponsive & flat again. I re-fitted the original chip and the car is back to normal.
I contacted the guy I bought the chip from and he reckons it could be to do with the knock sensors and the ignition over retarding.
Does this make sense? If so is there a way to fix this? or do any of you have any ideas what it could be?
I am going to replace the plugs at the weekend and try the chip again - the plugs haven't been changed for over 3 years.
Cheers.
Replacement Chip for ECU
Moderator: martauto
-
Speedtouch
- Old Skooler

- Posts: 14130
- Joined: Tue Feb 14, 2006 11:00 pm
- Location: Canterbury
IIRC, You're supposed to let the engine idle for 10 mins immediately after fitting a new chip (or even after any disconnection of the ECU/battery) in order to let it learn the basic idle settings, then go for a drive - during which it will feel initially lumpy and rough, even flatspotting (bogging down) at times, but after a while it should all smoothen out and enable you to extend up to the rev limit that the chip allows.
New spark plugs may well help too!
New spark plugs may well help too!
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421

