Removing SUmp on M42

Need technical Q/A then you're in the right place

Moderator: martauto

Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Sun Jan 07, 2007 1:35 pm

How much of a pain is it removing the sump on an M42 as it looks like my sump gasket might have gone!

Had a look at the engine i've got out of the car and it looks like there two bolts that actually sit inside the bell housing, is this the case?

Dave
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
stuartgallafant
E30 Zone Addict
E30 Zone Addict
Posts: 4531
Joined: Tue Mar 29, 2005 11:00 pm
Location: Costa del Croydon

Post Sun Jan 07, 2007 5:09 pm

kedge, IIRC, there are two bolts on the side of the sump that go to the bell housing, but not behind/inside the bell housing... but im not 100% sure!

also, an engine brace will be a great help, which will allow you to drop the front subframe away from the car
Image
Dan318-is
Married to the E30 Zone
Married to the E30 Zone
Posts: 8006
Joined: Wed Jul 06, 2005 11:00 pm
Location: Surrey/London

Post Sun Jan 07, 2007 5:13 pm

The lower sump simply pulls of; 20x 10mm hexbolts and thats that; easy to change the gasket; the upper sump however im not so sure i think its a case of the lower timing case etc being removed.

Lower sump should be a doddle though
stuartgallafant
E30 Zone Addict
E30 Zone Addict
Posts: 4531
Joined: Tue Mar 29, 2005 11:00 pm
Location: Costa del Croydon

Post Sun Jan 07, 2007 5:19 pm

dan, from reading his thread, i assumed he was talking about his upper sump!

stevie wonder could remove the lower sump...
Image
Kedge
Old Skooler
Old Skooler
Posts: 7698
Joined: Thu Jan 13, 2005 11:00 pm
Location: Leicestershire

Post Sun Jan 07, 2007 6:01 pm

Upper sump it is indeed guys, maybe a job for when i renew the steering rack on roll bar then! :roll:
Image
'86 Polaris 316 M20B28 Rebuild
Instagram - Kedge85
stuartgallafant
E30 Zone Addict
E30 Zone Addict
Posts: 4531
Joined: Tue Mar 29, 2005 11:00 pm
Location: Costa del Croydon

Post Sun Jan 07, 2007 10:34 pm

maybe mate. i wouldnt say its a difficult job, but its a drawn out affair!!

if it aint leaking that bad, then i would save it for a sunny day! just keep your eye on it
Image
Bob_S
Engaged to the E30 Zone
Engaged to the E30 Zone
Posts: 5412
Joined: Sat Jun 11, 2005 11:00 pm
Location: chester, cheshire

Post Sun Jan 07, 2007 11:16 pm

about 3hrs work... I unbolted the engine and lifted it on a jack to get the sump out when I smashed my lower sump
Bollocks to this 24v scrap!