valve stem seals
Moderator: martauto
-
jcjdavis1
- E30 Zone Camper

- Posts: 1128
- Joined: Thu Apr 13, 2006 11:00 pm
- Location: Paisley Scotland
Hi How easy are they to change on a 320i.I have the head off, but I cannot find any help in the search section.thanks

-
Templ8e30
- E30 Zone Addict

- Posts: 2801
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Ashton-under-Lyne, Lancashire
You need to remove the valves first.
Get a valve spring compressor from the likes of halfrauds to compress the springs, there is a split collar attached to the valve stem that needs to be removed then release the compressor and remove the springs and valve.
The old seals are a pain to remove, a pair of good pliers and a wiggling motion will do it. Don't grab them too hard with the pliers or you'll break the top of the valve guides.
Use a socket to press the new ones in (12mm iirc) being careful not to damage the spring on the seals.
This job is covered in the haynes manual.
Cheers,
Iain T
Get a valve spring compressor from the likes of halfrauds to compress the springs, there is a split collar attached to the valve stem that needs to be removed then release the compressor and remove the springs and valve.
The old seals are a pain to remove, a pair of good pliers and a wiggling motion will do it. Don't grab them too hard with the pliers or you'll break the top of the valve guides.
Use a socket to press the new ones in (12mm iirc) being careful not to damage the spring on the seals.
This job is covered in the haynes manual.
Cheers,
Iain T

2007 Mazda 6 2.0 estate
Political Correctness - A concept based on the idea that its possible to pick up a turd by the clean end !
-
Dan318-is
- Married to the E30 Zone

- Posts: 8006
- Joined: Wed Jul 06, 2005 11:00 pm
- Location: Surrey/London
I used an 11mm socket for the seals; apart from that what he said^
-
jcjdavis1
- E30 Zone Camper

- Posts: 1128
- Joined: Thu Apr 13, 2006 11:00 pm
- Location: Paisley Scotland
Thanks guys,I took the old head to my work and let the mechanic have a go, a pig of a job to get large cog at the end off.I will print off what you have said and look in the manual.

-
Chris-W
- E30 Zone Team Member

- Posts: 7219
- Joined: Tue May 24, 2005 11:00 pm
- Location: South Cheshire
-
jcjdavis1
- E30 Zone Camper

- Posts: 1128
- Joined: Thu Apr 13, 2006 11:00 pm
- Location: Paisley Scotland
Hi Chris should have taken you up on the c/head as this is turning out to be a nightmare.(the road to hell is paved with good intentions).Hopefully no prob with head just getting all the bits done. Jim


