Damper housing

Need technical Q/A then you're in the right place

Moderator: martauto

carpmart
E30 Zone Newbie
E30 Zone Newbie
Posts: 97
Joined: Thu Sep 21, 2006 11:00 pm
Location: Bedfordshire J12 M1

Post Sat Dec 30, 2006 12:04 pm

Guys

I have an issue with the large threaded retainer on the shock absorber holder on my 325 front legs. The internal diameter is too small for the top of my new LIP gas shocks! Got the shocks cheap but with no tops hence the issue! According to my verniers, I need 44 mm internal diameter. The ones I have in stock all seem to be about 42.5 mm which just wont fit!

Can anyone tell me where I can buy one from or does anyone have one knocking about they would send on?

Another question, I have welded a couple of repairs on one of the legs where the tin worm had got them at the point where the bottom of the spring is held. Is this ok for the MOT?

Thanks!

:D