OBs - Well here she is....

Show off your pride and joy here

Moderator: martauto

OBs
E30 Zone Squatter
E30 Zone Squatter
Posts: 1655
Joined: Thu Nov 02, 2006 11:00 pm
Location: Torbay, Devon

Post Fri Dec 29, 2006 8:19 pm

This is my first E30, I was looking at buying a Chrome bumper pre face lift two door, I really wanted a 2.5 winkeye But.. Dosnt everyone?!

Anyway its a 1.8 which is good enough for now! has no electric windows which I dont mind and no sunroof!

Inside:

It has bog standard interior, a Z3 1.9 shifter (cheers Eko!) :thumb: I also got a leak with the car free of charge of coarse, I did get it from Wales! :mad: and have started to search for it / them, I removed the carpet today, there was abit of a pond in the passanger footwell so removed the drain plugs and will now remove the dash / glove box and search for the exact cause....

Outside:

Minor body work needed really, rear wheel arches, bottom of passanger side door, scuttle panel looks fine, small scabs of rust around rear lights, both front and rear valances and jacking points are all surprisingly clean and it has one small hole underneith thats all I have found so far until I remove the dash :?

Lowered 40mm all round, with Bilsteins on the rear, sitting on 14" BBS's
and a twin exhaust back box around the back...

Plans:

Well in a nut shell - A Chrome Euro sleeper...

I am going to leave all the bodywork totally standard remove rear spoiler, aerial, side repeaters and passanger side door lock welding plates over the holes then finish by adding fogs, Leather, 16" Rims, Stainless Exhaust system and of coarse ill be slamming it!! Oh almost forgot :roll: A stonking great big engine M50??

Nudge nudge Tony :wink:

So what do you think?

Andy
Last edited by OBs on Sat Dec 30, 2006 10:29 am, edited 6 times in total.
eko
Old timer
Posts: 11531
Joined: Sat Feb 05, 2005 11:00 pm
Location: South Devon

Post Fri Dec 29, 2006 8:32 pm

Looks stunning Andy :mad:
Image
OBs
E30 Zone Squatter
E30 Zone Squatter
Posts: 1655
Joined: Thu Nov 02, 2006 11:00 pm
Location: Torbay, Devon

Post Fri Dec 29, 2006 8:35 pm

Yea Ive emailed you the pics so get your arse in gear!!! Oooops :roll: Having a blonde moment!

Ive deleted Imageshack? Dont know how but will have to re install :mad:
eko
Old timer
Posts: 11531
Joined: Sat Feb 05, 2005 11:00 pm
Location: South Devon

Post Fri Dec 29, 2006 9:07 pm

Here you go mate!
Oh and heres the link to imageshack - http://www.imageshack.us/


Image
Image
Image
Image
Image
Image
Image
Image
Image
OBs
E30 Zone Squatter
E30 Zone Squatter
Posts: 1655
Joined: Thu Nov 02, 2006 11:00 pm
Location: Torbay, Devon

Post Fri Dec 29, 2006 9:46 pm

Cheers once again mate!
spook
League two here we come !!!
Posts: 7583
Joined: Sat Aug 19, 2006 11:00 pm
Location: portsmouth

Post Fri Dec 29, 2006 9:56 pm

obs good luck with this project, i had water coming in from behind the fusebox, just in the corner by the bulkhead and was coming into the car thru those silver bits[whatever they are?] in the last picture above,anyone know what these are, good luck mate, when do you hope to get it finished by
Speedtouch
Old Skooler
Old Skooler
Posts: 14130
Joined: Tue Feb 14, 2006 11:00 pm
Location: Canterbury

Post Fri Dec 29, 2006 10:03 pm

Good idea to remove the carpets to deal with the rust/leak issues. Was it hard to get them out? Car looks pretty good otherwise.
///M aurice
ECU Upgrade EPROM Chips, £40 posted within the UK. Note these are not Zone chips.
viewtopic.php?f=6&t=279421
OBs
E30 Zone Squatter
E30 Zone Squatter
Posts: 1655
Joined: Thu Nov 02, 2006 11:00 pm
Location: Torbay, Devon

Post Fri Dec 29, 2006 11:22 pm

Cheers guys, Spook - You can see in the picture (Silver bit as you called it) there is a line of rusty water that has been trickling down.... I hope to finish it one day? But when... Ha! Money, time and availability of parts and so on are the main barriar!! Ill get the body work done first so its a mint shell and keep my eyes pealed....

320ise - The carpet was shagged anyway mate... But it is easy to get out really apart from beneith the heater area which I just cut around with a mini bread knife!! God knows how Im going to get a new one out without having to cut it! Mind you I can always butcher the scrap heater area!! :mad:
SPADGE
Married to the E30 Zone
Married to the E30 Zone
Posts: 7373
Joined: Wed Aug 09, 2006 11:00 pm
Location: Milton Keynes, Bucks

Post Fri Dec 29, 2006 11:26 pm

Remove the 2 nuts securing the 'silver bit' and open your glove box and it will fall out. I'll put money on it being a tad rotten around the rubber bulkhead wiring bung behind there!
Best of luck with it mate 8)
Engine conversions, Auto to manual conversions, parts, servicing etc etc... For anything e30 call 07718 901737
beardymat
E30 Zone Squatter
E30 Zone Squatter
Posts: 1979
Joined: Tue Jun 14, 2005 11:00 pm
Location: sheffield, city of steel, and rust apparently

Post Fri Dec 29, 2006 11:29 pm

check for rust under the fuse box and around the big squarish grommet where the wires come through the bulkhead and also check the drain for the place where the wiper motor sits (black trunk like tube on the drivers side near the battery) if this is blocked it all fills with water and runs in through the heater box
No longer self employed but still available for welding duties.
OBs
E30 Zone Squatter
E30 Zone Squatter
Posts: 1655
Joined: Thu Nov 02, 2006 11:00 pm
Location: Torbay, Devon

Post Sat Dec 30, 2006 10:39 am

Cheers guys... I put a post up in 'E30 BMW Chat' under 'Leak in car? Any common places?' So any advice on leaks and places to look can be found there...

I payed 100 quid for her as she stands, The only thing I have added so far is the Z3 shifter

Andy
E30Mark
E30 Zone Team Member
E30 Zone Team Member
Posts: 8107
Joined: Sun Jan 09, 2005 11:00 pm
Location: Wimborne, Dorset

Post Sat Dec 30, 2006 2:18 pm

OBs wrote:
I am going to leave all the bodywork totally standard remove side repeaters......
Be prepared for it to fail the MOT then :D unless it's a very early model....

Not bad for £100 though, good luck with her!
1 & 2 bed flats in Bournemouth areas, with parking
PM for details
OBs
E30 Zone Squatter
E30 Zone Squatter
Posts: 1655
Joined: Thu Nov 02, 2006 11:00 pm
Location: Torbay, Devon

Post Sat Dec 30, 2006 4:26 pm

E30Mark wrote:
OBs wrote:I am going to leave all the bodywork totally standard remove side repeaters......
Be prepared for it to fail the MOT then :D unless it's a very early model....
Not bad for £100 though, good luck with her!
Hi Mark, Thanks Im pretty pleased with it! Its a E reg and I have already thought about the side repeaters, I will proberly relocate them somewhere on the side of the car winkeye Thanks.

Today I have been working again in the p1ssing rain, Which in one way is good for finding leaks :D Searched most of the under dash area and so far all I have found is the 'Wiring loom gromet' was leaking as suggested by quite a few of you... The heater box / matrex looks to be fine. I still have to check around the Wiper motor.
The battery tray and its join to the bulk head is clean... and as is most of the bulk head joins etc (Apart from the loom gromet of coarse!)

The clutch housing has a gromet that looks a tad worse for wear (Photo) and starting to rust, Anyone replaced one of these before? It looks as though it is just a 'Donut' shaped gromet with a join so I shouldnt have to remove the peddle assembly?

Image
Image