Another M10 question!!

Need technical Q/A then you're in the right place

Moderator: martauto

RugbySteve
E30 Zone Newbie
E30 Zone Newbie
Posts: 88
Joined: Thu Jun 29, 2006 11:00 pm
Location: Norwich - 1986 318i Owner

Post Thu Dec 28, 2006 1:13 pm

On boxing day and then again yesterday my 1986 318i covered 230 miles each day, she ran like a dream crusing at between 80 and 90 for the whole trip!!

But the temp gague was all over the place!! She normally sits at just over half way but at times she crept up to nearly 3/4 before coming back down and then at times she would sit dead on half way!!! (im guessing at times the fan was cutting in???)

I have changed the thermostat and beacuse of this she has new coolant, but would a temp sensor change be in order? or are there any other items which I can check / change?!?!

Oh she also has a new radiator / pipes!!

Cheers!!
Gortour
E30 Zone Team Member
E30 Zone Team Member
Posts: 9025
Joined: Sat Sep 23, 2006 11:00 pm
Location: Poole, Dorset

Post Thu Dec 28, 2006 1:47 pm

If the radiator fan is a viscous one, it may be sticking. Therefore no cooling fan. If electric fan, then possibly the fan thermostat has started playing up and it kicks in too high.
Either way, check the fan.
Currently slumming it in an E46 Touring
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Thu Dec 28, 2006 7:27 pm

Tighten the small brass nut on the back of the instrument cluster, directly behind the temp gauge.
RugbySteve
E30 Zone Newbie
E30 Zone Newbie
Posts: 88
Joined: Thu Jun 29, 2006 11:00 pm
Location: Norwich - 1986 318i Owner

Post Fri Dec 29, 2006 9:24 am

Does anyone have any instructions as to how I remove the cluster to tighten said brass nut??!?!!
Gortour
E30 Zone Team Member
E30 Zone Team Member
Posts: 9025
Joined: Sat Sep 23, 2006 11:00 pm
Location: Poole, Dorset

Post Fri Dec 29, 2006 10:50 am

Drop the knee panel, and remove two large round nuts on the back of the trim piece at the bottom of the cluster and remove it. (runs between steering column and cluster). Remove two screws in the trim around the top of the cluster, and slide out. You'll then see 4 screws, 2 in the bottom and 2 in the top corners. Remove these and gently tip the cluster forward from the top.
You should get away without removing the steering wheel, but it can be easier if you do. Remember the steering wheel will not come off the steering column without the key turned slightly in the ignition to disengage the steering lock.
Currently slumming it in an E46 Touring
RugbySteve
E30 Zone Newbie
E30 Zone Newbie
Posts: 88
Joined: Thu Jun 29, 2006 11:00 pm
Location: Norwich - 1986 318i Owner

Post Fri Dec 29, 2006 11:37 am

well that sounds easy!!! 8O