M50 sump gasket

Need technical Q/A then you're in the right place

Moderator: martauto

DanThe
E30 Zone Team Member
E30 Zone Team Member
Posts: 28649
Joined: Sat Sep 10, 2005 11:00 pm
Location: Staffs

Post Thu Dec 28, 2006 11:27 am

Ive just got hold of another steel type and inside the card there is a slip of paper refering to a type of sealant to use.

Image

I never used sealant on the last that I fitted and have had no problems.
Anyone else heard of this?
ian332isport
E30 Zone Team Member
E30 Zone Team Member
Posts: 5380
Joined: Wed Dec 22, 2004 11:00 pm
Location: West Sussex

Post Thu Dec 28, 2006 12:36 pm

Dan,

You should use a smear of silicone sealer where the gasket crosses the joints between the block and the timing/oil seal covers. The rest of the sealing faces should be spotlessly clean and degreased, but no sealer added.

If this is not done, you quite often find oil will weap along these joints. It is standard BMW practice to use silicone on these joints.

Ian.
If it aint broke - Modify it...
Demlotcrew
E30 Zone Team Member
E30 Zone Team Member
Posts: 13329
Joined: Mon Dec 20, 2004 11:00 pm
Location: East Anglia

Post Thu Dec 28, 2006 2:22 pm

Where there is a hole on the gasket and no bolt goes through it you should fill the hole with a sealent.

Andrew
DanThe
E30 Zone Team Member
E30 Zone Team Member
Posts: 28649
Joined: Sat Sep 10, 2005 11:00 pm
Location: Staffs

Post Thu Dec 28, 2006 4:55 pm

Thanks lads :thumb: