trolley jack help
Moderator: martauto
-
spook
- League two here we come !!!
- Posts: 7583
- Joined: Sat Aug 19, 2006 11:00 pm
- Location: portsmouth
ive just bought a trolley jack and some axle stands, and i need to get underneath the front of the car, do i jack the car up on one side at a time and put an axle stand on each side as i go, or is there anywhere undr the engine bay where i can lift up in one go, cheers spooks, the complete novice, and what about the rear of the car, cheers
-
ajm-e30
- E30 Zone Regular

- Posts: 472
- Joined: Sat Nov 11, 2006 11:00 pm
- Location: newport,land of sheep sh***ers
if u can get to the front of the subframe then use that mate but its safer to use the jacking points really

-
smithy318i
- Engaged to the E30 Zone

- Posts: 5797
- Joined: Thu Apr 28, 2005 11:00 pm
- Location: Tyne & Wear
jack up one side at a time. and place the axle stands under the square sections of the chassis.
as for the rear, i have always used the section where the subframe bushes are attached to the sills.
as for the rear, i have always used the section where the subframe bushes are attached to the sills.
Last edited by smithy318i on Wed Dec 27, 2006 6:02 pm, edited 1 time in total.

-
spook
- League two here we come !!!
- Posts: 7583
- Joined: Sat Aug 19, 2006 11:00 pm
- Location: portsmouth
thanks fellas, better safe than sorry
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Which are NOT the inviting looking brackets at the back of the front wheel arches!ajm-e30 wrote:if u can get to the front of the subframe then use that mate but its safer to use the jacking points really
-
ajm-e30
- E30 Zone Regular

- Posts: 472
- Joined: Sat Nov 11, 2006 11:00 pm
- Location: newport,land of sheep sh***ers
as above, use a chassis rail rather than the chocolate like sills

-
charlE30
- E30 Zone Addict

- Posts: 3818
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Warwick

BMW E30 344i track car 
BMW F31 335d xdrive
BMW F31 335d xdrive
-
spook
- League two here we come !!!
- Posts: 7583
- Joined: Sat Aug 19, 2006 11:00 pm
- Location: portsmouth
could have done with that this morning after slightly crushing one jacking point
, now i know 
-
reddevil
- E30 Zone Regular

- Posts: 414
- Joined: Mon Jul 04, 2005 11:00 pm
- Location: Stockton, Teesside, UK
I did the same first time round a few months ago Spook, a bit of wood and a hammer to straighten it out should be ok though I've never dared do the rear wheels since no one seems to be able to agree on the best jacking point (I asked the question months ago).
Red D
Red D
1991 (H) 318iS Diamond Black, M-tech II spoiler.
K&N Panel filter-Viper2 chip-Zone BBTB
XBOX LIVE - reddevil1976
K&N Panel filter-Viper2 chip-Zone BBTB
XBOX LIVE - reddevil1976
