just wondering if anyone knows exactly how its done as i think i may have done it wrong
also a pic of a prop mount "facing the right direction" would be of great help.
i am troubleshooting a drive line shunt between gears and suspect the above as the culprit.
exactly how do you preload the prop mount?
Moderator: martauto
-
oze30
- E30 Zone Addict

- Posts: 4133
- Joined: Mon Oct 24, 2005 11:00 pm
- Location: Sydney
to preload you slacken the bolts that hold the centre bearing, then slide it towards the front of the car about an inch (?) then tighten. I think the extended bit past the metal bracket points to the front.. though dont quote me on that
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
I would limit the preload to about 5mm if I were you.
Should be done with the clamping sleeve nut slackened off and then tightened afterwards.
Should be done with the clamping sleeve nut slackened off and then tightened afterwards.
-
liam012
- E30 Zone Camper

- Posts: 1424
- Joined: Sun Aug 28, 2005 11:00 pm
thanks for that - i didnt slacken of the clamping sleeve when i did it,
still not sure if mine is facing the wrong way though, will have a gander - i presume threy would of made it obvious the correct direction to put it on and i have enough faith in myself to think i would of spotted it! so hopefuly no prop removal required this week!
still not sure if mine is facing the wrong way though, will have a gander - i presume threy would of made it obvious the correct direction to put it on and i have enough faith in myself to think i would of spotted it! so hopefuly no prop removal required this week!

-
Templ8e30
- E30 Zone Addict

- Posts: 2801
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Ashton-under-Lyne, Lancashire
Iirc the mounting is offset to one side, if you have it the wrong way it won't sit in the transmission tunnel properly.
Cheers,
Iain T
Cheers,
Iain T

2007 Mazda 6 2.0 estate
Political Correctness - A concept based on the idea that its possible to pick up a turd by the clean end !
