ICV testing

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
rj
E30 Zone Newbie
E30 Zone Newbie
Posts: 177
Joined: Fri Dec 01, 2006 11:00 pm

Post Thu Dec 21, 2006 5:55 pm

Hi guys

I've got a 1990 320i with a slightly low tickover.

I cleaned the ICV and carried out an ohmage check which was fine.

On carrying out the visual check of the valve, it did not go to the semi-open position but closed fully, when connecting it to the connector and switching on the ignition.

I picked up another one from a recycler to double check and the result was the same. The ohmage check was fine but the valve fully closed. Is this usual as I find it difficult to believe that both ICV's are defective?

Thanks.
Templ8e30
E30 Zone Addict
E30 Zone Addict
Posts: 2801
Joined: Mon Jan 10, 2005 11:00 pm
Location: Ashton-under-Lyne, Lancashire

Post Fri Dec 22, 2006 4:37 pm

The best and easiest way I've found to test ICV's is to plug them in and turn the ignition on but don't start it.

The ICV should buzz, all the knackered ones I've had don't buzz.

Cheers,

Iain T
Image
2007 Mazda 6 2.0 estate
Political Correctness - A concept based on the idea that its possible to pick up a turd by the clean end !
User avatar
rj
E30 Zone Newbie
E30 Zone Newbie
Posts: 177
Joined: Fri Dec 01, 2006 11:00 pm

Post Sat Dec 23, 2006 6:24 pm

Templ8e30 wrote:The best and easiest way I've found to test ICV's is to plug them in and turn the ignition on but don't start it.

The ICV should buzz, all the knackered ones I've had don't buzz.

Cheers,

Iain T
Thanks for that Iain.

The ICV buzzes and the ohmage readings are spot on too.

If the ICV is ok, do you have any other suggestions to eliminate this slightly low idle?
User avatar
Brianmoooore
E30 Zone Team Member
E30 Zone Team Member
Posts: 49360
Joined: Mon Jan 10, 2005 11:00 pm

Post Sat Dec 23, 2006 7:56 pm

What makes you think the idle is low?
User avatar
rj
E30 Zone Newbie
E30 Zone Newbie
Posts: 177
Joined: Fri Dec 01, 2006 11:00 pm

Post Sat Dec 23, 2006 9:13 pm

Brianmoooore wrote:What makes you think the idle is low?
The car is idling at about 700rpm and not within the 760 +/-40 spec. It is therefore a little uneven at tickover.

The car is a 320iA and when the box is put into drive and the car is at a standstill, the revs undulate between 650-700 emphasising the slight unevenness even more, almost resembling a very slight miss.