Cranking engine after rebuild....

Need technical Q/A then you're in the right place

Moderator: martauto

kam-325i
E30 Zone Team Member
E30 Zone Team Member
Posts: 4851
Joined: Tue Sep 27, 2005 11:00 pm
Location: TELFORD !!!! (Shropshire) Stevetigger Land !!!

Post Sat Dec 23, 2006 8:31 pm

Any of you guys got any tips on what to do to the engine just before you start it for the first time after a major head rebuild.

Engine has been still for a good 3 months. I have been checking cylinder bores every weekend and coating block and bores with clean oil.
Pete don't care about colour, He would shag a rainbow if he could find the end of it....
Image
Andy335Touring
Married to the E30 Zone
Married to the E30 Zone
Posts: 7144
Joined: Sun Jan 09, 2005 11:00 pm
Location: Long Eaton,Nottingham

Post Sat Dec 23, 2006 8:50 pm

Battery fully charged and conected up to a decent charger, drizzle some oil over the cam/rockers/etc, disconect the fuel pump relay and crank it over till the oil light goes out.

Reconect the relay and fingers crossed ! :)
Andy335Touring
Married to the E30 Zone
Married to the E30 Zone
Posts: 7144
Joined: Sun Jan 09, 2005 11:00 pm
Location: Long Eaton,Nottingham

Post Sat Dec 23, 2006 8:51 pm

BTW remove excess oil from the bores before putting the head back on
kam-325i
E30 Zone Team Member
E30 Zone Team Member
Posts: 4851
Joined: Tue Sep 27, 2005 11:00 pm
Location: TELFORD !!!! (Shropshire) Stevetigger Land !!!

Post Sat Dec 23, 2006 9:00 pm

The fuel system was killed when i stripped the engine, I shall clean the bores and block before the head goes back on.

I was worred about the cam and rocker.......
Pete don't care about colour, He would shag a rainbow if he could find the end of it....
Image
Andy335Touring
Married to the E30 Zone
Married to the E30 Zone
Posts: 7144
Joined: Sun Jan 09, 2005 11:00 pm
Location: Long Eaton,Nottingham

Post Sat Dec 23, 2006 9:15 pm

kam-325i wrote:
I was worred about the cam and rocker.......
In what way ?
Turbo-Brown
Boost Junkie
Posts: 4705
Joined: Tue Feb 15, 2005 11:00 pm
Location: Aldershot, Hants

Post Sat Dec 23, 2006 11:52 pm

Cam should be coated in assembly lube.

Bores should be lightly oiled (and that'll protect them from rust forever pretty much)

Take the plugs out, isolate the ignition coil, isolate the injectors.

Crank the engine over until the oil pressure light goes out as the oil system will be empty. This will take an age to do!

Once you've established that the oil system's working, put the plugs back in, reconnect the injectors and ignition systems, cross everything and turn the key.
325i Twin Turbo (until 10am 01/12/07 :( )

www.air-in.co.uk free M20 exhaust and inlet flange