wiring for heated seats
Moderator: martauto
-
dips346
- London Meets Main Man
- Posts: 3977
- Joined: Fri Jan 14, 2005 11:00 pm
- Location: heston/heathrow
does anyone know what wiring goes where for heated seats as i dont have the loom but do have the switches and seats thanks
-
cliffybabe
- Powered by Nelly

- Posts: 10020
- Joined: Sun Dec 18, 2005 11:00 pm
- Location: Croydon
Dips Gallafant is talking about doing this mod 

Considering Selling the Cabby, looks like its gonna go
-
DJ_B4L
- E30 Zone Regular

- Posts: 973
- Joined: Sat May 14, 2005 11:00 pm
- Location: Kent
same here i have the seats not the wiring either dips look on german ebay i saw a set the other day
PIONEER AVIC X1, X1R, X1 BT LATEST SATNAV DISK WITH LATEST MAPS AND ALSO UPDATES FIRMWARE £20 POSTED PM FOR MORE DETAILS
Number plate for sale E30 2 HRD open to serious offers only will suit any E30
Number plate for sale E30 2 HRD open to serious offers only will suit any E30
-
GDBN
- E30 Zone Camper

- Posts: 1415
- Joined: Fri Apr 08, 2005 11:00 pm
- Location: Copenhagen
Can't remember which live I used in the end ... think it was one under the steering wheel.
How many wires are there at plug from the seat? 3?
G
How many wires are there at plug from the seat? 3?
G
-
SPADGE
- Married to the E30 Zone

- Posts: 7373
- Joined: Wed Aug 09, 2006 11:00 pm
- Location: Milton Keynes, Bucks
There is very little wiring actually and the live pick-up is inside the white block thing behind the glovebox.
Engine conversions, Auto to manual conversions, parts, servicing etc etc... For anything e30 call 07718 901737
-
stuartgallafant
- E30 Zone Addict

- Posts: 4531
- Joined: Tue Mar 29, 2005 11:00 pm
- Location: Costa del Croydon
as spadge said, the 'box-of-tricks' for the wiring is behind the glovebox. i think you need a relay and a couple of fuses too...
the actual wiring loom is seperate to the original loom in the car, and just simply plugs in, although to install properly, you have to remove the centre console, glovebox and carpet, which isnt hard is it...
cliffy, i'll have to fabricate my own loom, as i'll be using the heating elements from an E60 5 Series. that should be fun!
the actual wiring loom is seperate to the original loom in the car, and just simply plugs in, although to install properly, you have to remove the centre console, glovebox and carpet, which isnt hard is it...
cliffy, i'll have to fabricate my own loom, as i'll be using the heating elements from an E60 5 Series. that should be fun!
-
Demlotcrew
- E30 Zone Team Member

- Posts: 13329
- Joined: Mon Dec 20, 2004 11:00 pm
- Location: East Anglia
I done this years ago, its very simple one live and an earth like stu said.
Andrew
Andrew
-
Royalratch
- E30 Zone Addict

- Posts: 4921
- Joined: Sat Oct 21, 2006 11:00 pm
- Location: London
Don't need to remove carpet. Just run it from the accessory panel from behind the glovebox and down along the centre console.
Then the loom splits to feed each seat, run it under the carpet down either side of the transmission tunnel.
Then pop each feed out under each seat where the floor air/heater vents live.
You'll save yourself so much time and hassle by NOT lifting the carpet - don't do it.

Then the loom splits to feed each seat, run it under the carpet down either side of the transmission tunnel.
Then pop each feed out under each seat where the floor air/heater vents live.
You'll save yourself so much time and hassle by NOT lifting the carpet - don't do it.

-
stuartgallafant
- E30 Zone Addict

- Posts: 4531
- Joined: Tue Mar 29, 2005 11:00 pm
- Location: Costa del Croydon
-
Royalratch
- E30 Zone Addict

- Posts: 4921
- Joined: Sat Oct 21, 2006 11:00 pm
- Location: London
Well, if you want to give the interior a good scrub then do it.
But I ran mine as I explained and it's easier to get to if you need to repair etc.
If you take the centre / middle console off, you'll see that there are many pre-cut holes in the carpet on top of the transmission tunnel - you feed it down there and 'collect' it from the holes in the carpet under the seat you'll do it in half the time.
But I ran mine as I explained and it's easier to get to if you need to repair etc.
If you take the centre / middle console off, you'll see that there are many pre-cut holes in the carpet on top of the transmission tunnel - you feed it down there and 'collect' it from the holes in the carpet under the seat you'll do it in half the time.
-
stuartgallafant
- E30 Zone Addict

- Posts: 4531
- Joined: Tue Mar 29, 2005 11:00 pm
- Location: Costa del Croydon
-
Royalratch
- E30 Zone Addict

- Posts: 4921
- Joined: Sat Oct 21, 2006 11:00 pm
- Location: London
Naasti (northern accent).
-
gazza
- E30 Zone Camper

- Posts: 1266
- Joined: Tue Feb 08, 2005 11:00 pm
- Location: north london/herts
dips loom is part no 61 12 1 381 721....under £30 from your dealer ...relay is 61 31 1 373 585 also available then you only need the switches which you have
cheers
cheers
-
dips346
- London Meets Main Man
- Posts: 3977
- Joined: Fri Jan 14, 2005 11:00 pm
- Location: heston/heathrow
thanks everyone for your help
-
Royalratch
- E30 Zone Addict

- Posts: 4921
- Joined: Sat Oct 21, 2006 11:00 pm
- Location: London
Don't even need the relay of you have electric windows - same part.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Fuse is number 16, 15A and feeds down to pin U of the accessories socket. Top row, third from left, second from right.
The wire down from the fusebox is white/brown, and unfortunately is not fitted on some cars. You can see if it's there by looking at the outer slot of fuse 16, and seeing if there's a socket down there.
The wire down from the fusebox is white/brown, and unfortunately is not fitted on some cars. You can see if it's there by looking at the outer slot of fuse 16, and seeing if there's a socket down there.



