It will need a new head gasket so what I need is a list of parts that I will need plus advice on what to check for.Any help will be much appreciated.
320i Touring
Moderator: martauto
-
jcjdavis1
- E30 Zone Camper

- Posts: 1128
- Joined: Thu Apr 13, 2006 11:00 pm
- Location: Paisley Scotland
Hi Folks I am going to get a 320i Touring but need some tech. advice.
It will need a new head gasket so what I need is a list of parts that I will need plus advice on what to check for.Any help will be much appreciated.
It will need a new head gasket so what I need is a list of parts that I will need plus advice on what to check for.Any help will be much appreciated.
-
gcorky
- Boost Junkie
- Posts: 2009
- Joined: Tue Jul 12, 2005 11:00 pm
- Location: n.e england
ok then...
headgasket set
headbolts
timing belt-advise kit as best practice
good time to do waterpump
oil/filter/plugs/antifreeze etc
now the machine shop bits...head off crack test and skim .
note on the exhaust manifold nuts....soak em well with wd40 type stuff,if they snap obviously theyll need removing and new ones fitting..
give valve train a visual for pitting grooves,wear etc
may need engine flushing and cooling system flushing depending on cause.check viscous coupling on fan,and thermostat,if in doubt renew because a problem here would undo the money/work youve spent on headjob....
check valve clearances /reset if out of adjustment..theres some articles on this site if your not familiar ...good luck
any questions -fire away m8.
hth
Graham
headgasket set
headbolts
timing belt-advise kit as best practice
good time to do waterpump
oil/filter/plugs/antifreeze etc
now the machine shop bits...head off crack test and skim .
note on the exhaust manifold nuts....soak em well with wd40 type stuff,if they snap obviously theyll need removing and new ones fitting..
give valve train a visual for pitting grooves,wear etc
may need engine flushing and cooling system flushing depending on cause.check viscous coupling on fan,and thermostat,if in doubt renew because a problem here would undo the money/work youve spent on headjob....
check valve clearances /reset if out of adjustment..theres some articles on this site if your not familiar ...good luck
any questions -fire away m8.
hth
Graham
Last edited by gcorky on Thu Dec 14, 2006 12:34 am, edited 1 time in total.
-
jcjdavis1
- E30 Zone Camper

- Posts: 1128
- Joined: Thu Apr 13, 2006 11:00 pm
- Location: Paisley Scotland
good man and thanks for quick reply Jim

-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Note of caution. What makes you think it needs a head gasket? Most 6 pots sold "in need of a head gasket" turn out to have a cracked head. 325s more than 320s, but the 320 isn't immune.
-
gcorky
- Boost Junkie
- Posts: 2009
- Joined: Tue Jul 12, 2005 11:00 pm
- Location: n.e england
Brianmoooore wrote:Note of caution. What makes you think it needs a head gasket? Most 6 pots sold "in need of a head gasket" turn out to have a cracked head. 325s more than 320s, but the 320 isn't immune.
crack test /skim will tell him this -as advised but still need the parts and checks above...out of curiousity though,whats the problem/symptom..
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
OP says he is GOING to get a 320.gcorky wrote:Brianmoooore wrote:Note of caution. What makes you think it needs a head gasket? Most 6 pots sold "in need of a head gasket" turn out to have a cracked head. 325s more than 320s, but the 320 isn't immune.
crack test /skim will tell him this -as advised but still need the parts and checks above...out of curiousity though,whats the problem/symptom..
"just needs a head gasket, mate" is a well used phrase by vendors. If it turns out to be a cracked head, then it could be the difference between a bargain and not such a bargain.
-
gcorky
- Boost Junkie
- Posts: 2009
- Joined: Tue Jul 12, 2005 11:00 pm
- Location: n.e england
-
jcjdavis1
- E30 Zone Camper

- Posts: 1128
- Joined: Thu Apr 13, 2006 11:00 pm
- Location: Paisley Scotland
Hi buying the car from a mate who was the mechanic at my work, it boiled up and in his opinion it neede a new head gasket.He managed to get it stopped before any serious damage was done I hope.I am going to get the head pressure tested to make sure it is ok.Then fix and get it on the road and see why everyone raves about 6 pot.
So thank you all for your imput and will post pics. once I have the car.
So thank you all for your imput and will post pics. once I have the car.

-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Couple of things to check before you rip it apart.
Did it overheat when being driven along, or when in traffic/idling. If the latter check the viscous fan coupling.
Check the small rubber hose that runs from the top of the radiator to the neck of the header tank isn't blocked.
Check that the thermostat hasn't broken in the bypass position by checking that the radiator gets hot.
Did it overheat when being driven along, or when in traffic/idling. If the latter check the viscous fan coupling.
Check the small rubber hose that runs from the top of the radiator to the neck of the header tank isn't blocked.
Check that the thermostat hasn't broken in the bypass position by checking that the radiator gets hot.
-
jcjdavis1
- E30 Zone Camper

- Posts: 1128
- Joined: Thu Apr 13, 2006 11:00 pm
- Location: Paisley Scotland
Hi The car was on motorway next to slip for service area engine started to overheat and steam so he pulled into service area and stopped engine,has'nt been started since.So far he has the rad.off but has not got the time to fix so I have taken on the task.Is it wise to put rad.back on to test the above and risk more damage?

-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
I'd definitely put the rad back in and fill with water if that's all that's dismantled.
Careful you don't get an airlock when you refill (turn the heater full on and check it starts to blow warm air within a couple of minutes of starting the engine.
You're unlikely to do any further damage if you watch the temperature gauge and switch off at the first signs of anything untoward.
Careful you don't get an airlock when you refill (turn the heater full on and check it starts to blow warm air within a couple of minutes of starting the engine.
You're unlikely to do any further damage if you watch the temperature gauge and switch off at the first signs of anything untoward.
-
jcjdavis1
- E30 Zone Camper

- Posts: 1128
- Joined: Thu Apr 13, 2006 11:00 pm
- Location: Paisley Scotland
Hi I am picking the car up on Sunday so will have a chat with my mate and get the full story again as to what happened then make a decision on what to do. Thanks again for all the imput. Jim


