prpo lash under acceleration...help!

Need technical Q/A then you're in the right place

Moderator: martauto

liam012
E30 Zone Camper
E30 Zone Camper
Posts: 1424
Joined: Sun Aug 28, 2005 11:00 pm

Post Wed Dec 13, 2006 12:07 am

if i put the foot down very quickly there seems to be quite a lash down through the transmission back to the diff , its a brand new centre bearing and prop mount so all is tight there-
i did leave off the prop dampner but i'd heard all over the forum it was ok to do so,
have i got the pre-load wrong - it seemed easy just pushing the centre bearing 4 mm out then tightening>

any ideas as its a jolt that doesnt feel nice or kind to the car!

with a gentle right foot the problem is not there
Last edited by liam012 on Sat Dec 23, 2006 4:51 pm, edited 2 times in total.
Image
kam-325i
E30 Zone Team Member
E30 Zone Team Member
Posts: 4851
Joined: Tue Sep 27, 2005 11:00 pm
Location: TELFORD !!!! (Shropshire) Stevetigger Land !!!

Post Wed Dec 13, 2006 12:12 am

have you looked at the guibo/rubber things on the back of the gearbox and on the diif ?
Pete don't care about colour, He would shag a rainbow if he could find the end of it....
Image
liam012
E30 Zone Camper
E30 Zone Camper
Posts: 1424
Joined: Sun Aug 28, 2005 11:00 pm

Post Wed Dec 13, 2006 12:19 am

guibo good on the gearbox
but i dont have a guibo on my diff to prop joint?!
is that right?....
Image
kam-325i
E30 Zone Team Member
E30 Zone Team Member
Posts: 4851
Joined: Tue Sep 27, 2005 11:00 pm
Location: TELFORD !!!! (Shropshire) Stevetigger Land !!!

Post Wed Dec 13, 2006 12:24 am

Looking at the ETK you are right.......silly me !!!

Do you get it when you lift of the throttle ?
Pete don't care about colour, He would shag a rainbow if he could find the end of it....
Image
liam012
E30 Zone Camper
E30 Zone Camper
Posts: 1424
Joined: Sun Aug 28, 2005 11:00 pm

Post Wed Dec 13, 2006 12:46 am

cant remember exactly (only had 7 miles in her yet) but you know i think i do...
Image
kam-325i
E30 Zone Team Member
E30 Zone Team Member
Posts: 4851
Joined: Tue Sep 27, 2005 11:00 pm
Location: TELFORD !!!! (Shropshire) Stevetigger Land !!!

Post Wed Dec 13, 2006 12:53 am

If you are getting a clunk or knock on throttle lift off aswell, then something aint right.

Might be worth doing this, park the car, leave in gear, engine off, and see if you move the prop round with your hand, that might show any play in the prop, diff or gearbox joints.
Pete don't care about colour, He would shag a rainbow if he could find the end of it....
Image
liam012
E30 Zone Camper
E30 Zone Camper
Posts: 1424
Joined: Sun Aug 28, 2005 11:00 pm

Post Sat Dec 23, 2006 4:54 pm

ok when parked in first gear with handbrake on there is barely 1 degree play in the propshaft but when in neutral there seems to be almost 10 degrees! though some of this translates into an output shaft.v what can i do about this - i have just had the clutch packsin the lsd replaced.
quite annoying when yhou put the foot down.
Image
fuzzy
He who sleeps with "Gingers"
Posts: 14351
Joined: Sat Jun 04, 2005 11:00 pm
Location: melbourne Australia

Post Sat Dec 23, 2006 5:14 pm

i used to get a knock on hard take offs,turned out to be a rear subframe mount or without stating the obvious,did you put the centre bearing on the right way around as its off centre,i didnt the first time :roll:
liam012
E30 Zone Camper
E30 Zone Camper
Posts: 1424
Joined: Sun Aug 28, 2005 11:00 pm

Post Sat Dec 23, 2006 5:33 pm

thats a real possibility - will check the centre bearing housing/prop mount thanks

when you say "turned out to be a rear subframe mount" do you mean it was buggered or broke?
Image
fuzzy
He who sleeps with "Gingers"
Posts: 14351
Joined: Sat Jun 04, 2005 11:00 pm
Location: melbourne Australia

Post Sat Dec 23, 2006 9:44 pm

the rubber bush was perished.