Hi folks,
i am just about to get an mtech 1 front spoiler for my car and was wondering how easy a job it is to fit, carn't be that hard can it? any help as always much appriciated.
Cheers
Dom
fitting mtech 1 front spoiler
Moderator: martauto
-
dom-1984-320i
- E30 Zone Camper

- Posts: 1246
- Joined: Tue May 16, 2006 11:00 pm
- Location: Sunny Essex
-
Nelly
- Gumbo

- Posts: 4239
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Divorce Central
Piece of p1ss mate, simply remove the front bumper from the car, remove all the black trim pieces from it and line up the top edge of the tec 1 skirt to where the trim pieces fit, the trim basically hold the skirt on so, put all back together and replace on the car - when putting back on, the tec skirt has to lip around the return edge of the front panel(bottom of the wheel arch) - this is where you can use 2x self tapping screws on each side to hold the return sides of the skirt nice and firm.
Neil.
Neil.
-
dom-1984-320i
- E30 Zone Camper

- Posts: 1246
- Joined: Tue May 16, 2006 11:00 pm
- Location: Sunny Essex
Cheers Neil, all sounds pretty straight forward!

