After the car was thrashed hard, it would smoke when started up again. I figured valve stem oil seals because the symptoms were typical, so stuck a set it, but it was still more or less the same. So I figured oil scraper rings (compression was still good) so put a new set of piston rings in, still the same. So I thought poss breather blocked and pressurising the crankcase (looked like oil coming up the sprung pipe under the inlet manifold when the engine was stripped) but the rocker cover hose isn't collapsed, blows back clear through the rocker cover, and there is a good vacum on the throttle body. Tickover also drops when the oil cap is off, so seems all fine there. Anybody got any ideas before I stick another engine in? I'm all out of options.
Cheers
Brian
Smoking M20 2.0
Moderator: martauto
-
Brian28
- E30 Zone Squatter

- Posts: 1596
- Joined: Sat Jun 11, 2005 11:00 pm
- Location: Bournemouth
For sale - E30 320i racer project - sold.
-
SGP
- E30 Zone Regular

- Posts: 502
- Joined: Thu Aug 31, 2006 11:00 pm
Your probably getting a lot of oil sitting in the throttle body where the breather dumps into it,this wont be noticable during high speed/ hot running.I'd suggest you make sure all your gaskets are sealing properly,ie sump and rocker cover,dipstick "o"rings and all the breather hose clips.If all is tight the recycled gasses will flow better and reduce the liklihood of deposits pooling at the throttle body.lol.
If it ain't broke..
Fix it till it is
Fix it till it is
-
Brian28
- E30 Zone Squatter

- Posts: 1596
- Joined: Sat Jun 11, 2005 11:00 pm
- Location: Bournemouth
Thanks Stephen. All gaskets and seals good. This is a *lot* of oil smoke, not just a bit that clears with the first couple of throttle blips. Symptoms are like valve seals completely shagged, but they are definitely good and I'm lost for ideas. Looking like another engine unless anybody else comes up with something else to try.
Cheers
Brian
Cheers
Brian
For sale - E30 320i racer project - sold.
