Yesterday I changed the thermostat on my 318i m10 engine, decided to let all the coolant drain out and replace with new. In my aim to get a 50 50 mix of coolant and water I have ended up with more coolant than water in the system!!
My question is a easy one, will this matter??! Do I need to drain out some coolant and top up with water or will it be okay as it is?!?!! Temp level is spot on half way but havent taken her out on the open road yet its just been in city traffic!!!
Cheers!!!!
Question on coolant!!
Moderator: martauto
-
RugbySteve
- E30 Zone Newbie

- Posts: 88
- Joined: Thu Jun 29, 2006 11:00 pm
- Location: Norwich - 1986 318i Owner
-
tomtomiS
- E30 Zone Camper

- Posts: 1216
- Joined: Sun Aug 21, 2005 11:00 pm
- Location: Cricket Hill, Yateley
there is nothing to worry about, the higher the coolant to water ratio means the engine wont freeze at lower temperatures. having a higher concentration will raise the boiling point of the coolant but that wont cause any problems in my opinion
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Nothing to worry about. The higher concentration of antifreeze will marginally reduce the effectiveness of the coolant, but nowhere near enough to cause the slightest problem.
Draining the radiator on an E30, or even removing the water pump doesn't drain off all the coolant. You have to remove drain plugs on the engine block to do that.
Lazy way to change E30 coolant is to drain the radiator, then thoroughly flush both engine and radiator with a hosepipe to remove all traces of old coolant and hopefully some sediment.
Pour in the correct amount of concentrated antifreeze, top up with water and go through the usual air bleeding procedures.
Draining the radiator on an E30, or even removing the water pump doesn't drain off all the coolant. You have to remove drain plugs on the engine block to do that.
Lazy way to change E30 coolant is to drain the radiator, then thoroughly flush both engine and radiator with a hosepipe to remove all traces of old coolant and hopefully some sediment.
Pour in the correct amount of concentrated antifreeze, top up with water and go through the usual air bleeding procedures.
-
RugbySteve
- E30 Zone Newbie

- Posts: 88
- Joined: Thu Jun 29, 2006 11:00 pm
- Location: Norwich - 1986 318i Owner
Cool! (no pun intended!!) Seems then that all is okay!!
Looks like I have done well then with changing the thermostat!!! Only have the temperature sensor to change, this would have been done yesterday as well but my local BMW garage provided me with a single pin sensor when I needed a double pin one!!!
Have no idea what the difference is but guess its best to replace like for like!!!!!
Looks like I have done well then with changing the thermostat!!! Only have the temperature sensor to change, this would have been done yesterday as well but my local BMW garage provided me with a single pin sensor when I needed a double pin one!!!
Have no idea what the difference is but guess its best to replace like for like!!!!!
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Single pin temp sensor is the one for the temp gauge; the one for the ECU has two pins.


