Condensation inside bootlid

Need technical Q/A then you're in the right place

Moderator: martauto

User avatar
Mahmood
E30 Zone Camper
E30 Zone Camper
Posts: 1340
Joined: Mon Jan 10, 2005 11:00 pm
Location: People's Republic of Londonistan

Post Fri Dec 01, 2006 3:35 pm

Hi all
I had the boot lid open today and I noticed a lot of condensation on the underside of the bootlid.

Any idea why this would happen? Will it lead to rot somewhere eventually?
User avatar
Kos
E30 Zone Team Member
E30 Zone Team Member
Posts: 15448
Joined: Tue Jul 12, 2005 11:00 pm
Location: London / Cyprus

Post Fri Dec 01, 2006 3:41 pm

it will attack your rear end !!

boot lid rubber, light seals, and aireal are all prime suspects
User avatar
Mahmood
E30 Zone Camper
E30 Zone Camper
Posts: 1340
Joined: Mon Jan 10, 2005 11:00 pm
Location: People's Republic of Londonistan

Post Fri Dec 01, 2006 3:47 pm

it will attack your rear end !!
...Ooh Vicar, I hope not!!!

Seriously, thanks Kos. Ah ha...I know what it is...

I put some MHW rears on last week and I didn't get the right one on properly. Took them off today and there was some water in the right lense.

Put my original rear lenses back on today and will monitor over the next week.
User avatar
Estoril-5
E30 Zone Newbie
E30 Zone Newbie
Posts: 216
Joined: Sun Dec 11, 2005 11:00 pm
Location: Birmingham

Post Fri Dec 01, 2006 3:50 pm

Kos wrote:it will attack your rear end !!

boot lid rubber, light seals, and aireal are all prime suspects
i have this also, so what is the solution?

is there somekind of seal protector or something?
Image
User avatar
Kos
E30 Zone Team Member
E30 Zone Team Member
Posts: 15448
Joined: Tue Jul 12, 2005 11:00 pm
Location: London / Cyprus

Post Fri Dec 01, 2006 3:51 pm

you need to play around with the brackets to get them on right ( well you do with the early spec ones which i belive you have)


change them back and see what happens, new gaskets from BMW are cheap though so might be worth investing in some
User avatar
Mahmood
E30 Zone Camper
E30 Zone Camper
Posts: 1340
Joined: Mon Jan 10, 2005 11:00 pm
Location: People's Republic of Londonistan

Post Fri Dec 01, 2006 3:53 pm

Spot on Kos.

I didn't fit the right bracket properly and could only get on nut on it. There's not much room to turn a spanner in there!

Anyway, back to factory spec. now.
User avatar
Kos
E30 Zone Team Member
E30 Zone Team Member
Posts: 15448
Joined: Tue Jul 12, 2005 11:00 pm
Location: London / Cyprus

Post Fri Dec 01, 2006 4:01 pm

Mahmood wrote:Spot on Kos.

I didn't fit the right bracket properly and could only get on nut on it. There's not much room to turn a spanner in there!

Anyway, back to factory spec. now.
you need to grind them back some times, thats what i had to do in the past

any way, good luck