m20 cylinder head

[daveo]

just a quick question how long would it take to change the head on 320 also if i was to fit a uprated cam do i need to fit a aftermarket cam pulley.

[ajm-e30]

couple of hours mate, make sure u dont lose the spring n 2 washers off the breather pipe inbetwen the block n inlet

[ajm-e30]

the cam pulley should fit if its the later version

[daveo]

just to get this right with the uprated cam i can still use the factory fitted cam pulley

[ajm-e30]

yeah u should be able to mate, what cam u thinkin of??

[daveo]

i look at getting a piper fast road cam im not too sure on the duration of it i think it a 282.

[ajm-e30]

iv had one of those b4,didnt think much of it, im in the process of rebuilin my 731 head with a schrik cam i think its a 282/282 duration inlet/exhaust.

[daveo]

i had a schricks cam fitted in to my 316 that went a lot better afterwards.
ive only hear good thing 282/282 shricks cams i think i should get for my 320.

[daveo]

i had a schricks cam fitted in to my 316 that went a lot better afterwards.
ive only hear good thing 282/282 shricks cams i think i should get for my 320.

[ajm-e30]

i got a 2 door 320i, so much i got to do to it, only paid £100 for it!