Any ideas guys, it's a 327i M20 engine.
Car runs badly when cold
Moderator: martauto
-
chu346
- E30 Zone Addict

- Posts: 2403
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Leicester
For some reason my car runs really bad when cold, but as soon as its up to temperature its fine. It idles ok but starts to die when the throttle is pressed and I start to drive. It's also using lots of fuel when cold and possibly a little more when warm 
Any ideas guys, it's a 327i M20 engine.
Any ideas guys, it's a 327i M20 engine.
-
ed325i
- E30 Zone Addict

- Posts: 4146
- Joined: Mon Jan 10, 2005 11:00 pm
Could be the blue temp sensor.
-
chu346
- E30 Zone Addict

- Posts: 2403
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Leicester
I thought that causes the engine to over fuel when warm?
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
It does, or it can give your symtoms. Depends what's gone wrong with it.chu346 wrote:I thought that causes the engine to over fuel when warm?
-
chu346
- E30 Zone Addict

- Posts: 2403
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Leicester
It's bust 
I'll try a new one today. I only replaced this a year ago
Cheers
I'll try a new one today. I only replaced this a year ago
Cheers
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Measure the cold resistance of your sensor. Would expect something like 3500 - 4000 ohms this time of year.
-
chu346
- E30 Zone Addict

- Posts: 2403
- Joined: Mon Jan 10, 2005 11:00 pm
- Location: Leicester
I got about 4500?
Is that too much.
Is that too much.
-
Brianmoooore
- E30 Zone Team Member

- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
Sounds highish, but the temp up North where you are is probably less than I usually ever see.
In any case , it would have to be much lower (1000 ohms or less) to cause your problems. May be worth posting a normal running temp reading as well.
Next suggestion is to hunt for inlet side air leaks.
In any case , it would have to be much lower (1000 ohms or less) to cause your problems. May be worth posting a normal running temp reading as well.
Next suggestion is to hunt for inlet side air leaks.
