Badge positioning?

Post Fri Nov 10, 2006 9:05 pm

Following on from my post last night"what to stick badge on with",I know need the exact position to put it on!

Anyone fancy taking some measurements for me?
Say from the lower edge of the boot to the bottom of the badge,then from the right hand side of the boot to the `i`?
Oh and the width of the gap between the 5 and the i.

Badge in question is a 325i.

Thanks

Post Sat Nov 11, 2006 12:12 am

Anyone???

Post Sat Nov 11, 2006 12:21 am

Just measured mine......

Bottom of bootlid to bottom of badge = 15mm

Between 5 and i = 18mm

Edge of i to edge of bootlid = 32mm

Post Sat Nov 11, 2006 12:31 am

Thanks a lot mate,will give that ago tomorrow

Post Sat Nov 11, 2006 12:44 am

No worries...

Take your time fitting it. Badges are one of those things that really need to be nice and straight. If it's a little crooked, it will just bug you every time you look at it... or maybe I'm just a fussy bugger.
Hope it turns out well for you.

Post Sat Nov 11, 2006 12:46 am

aus325 wrote:No worries...

Take your time fitting it. Badges are one of those things that really need to be nice and straight. If it's a little crooked, it will just bug you every time you look at it... or maybe I'm just a fussy bugger.
Hope it turns out well for you.

Detail is important to me too,hence the original question.

Ill post a pic when ive done it,thanks for your help bud

Post Sat Nov 11, 2006 6:28 am

Here's what I copied from a site that I've since forgotten. Hope it helps.

Distance between 325 and right trunk edge
62mm (2.441 inches)

Distance between bottom of 325 and trunk bottom edge
19 mm (0.748 inches)

Distance between 325 and 'i' / 'e' emblem:
18mm (0.709 inches)

Distance betwen 'is' and 'iX' and right trunk edge
22 mm (0.866)