hi guys,
i bought a roof motor caseing, in cast steel. today i swapped all of the workings over into it and started to assemble it to the car. then i started to hit problems, i eventually managed to get it into place ( alot harder than taking the other one out), however the holes didnt align properly.i openned the holes up in the car but the and bolted it in place, but the piece doesnt sit flat to the car, and isnt tall enough for the arm to pivot around. has anyone encountered this before???any advice would be gret please. thanks all.
cab roof caseing
Moderator: martauto
-
DaveD
- E30Zone Wiki Specialist
- Posts: 5129
- Joined: Tue Jan 11, 2005 11:00 pm
- Location: Sheffield
ring jason who makes the things 07968 852 395