Dropped the entire rear suspension to allow me to change the bushes, the corroded rear brake lines, change the rear ARB drop links, sort some rust out around the tank filler neck and de-rust and paint the running gear. Bigger job than i expected!
Ran into a few problems, one the prop came apart as i dropped the diff which meant the entire exhaust system and heat shields had to be removed, and whoever did the rear bushes last used brute force and drill bits. Meaning i had to spend a few hours carefully welding and grinding to make it all good again before i could press the new bushes in
The bushes i used were brought from Motormec, i was assured they were Febi/Bilstein OE spec but i had my doubts, as discussed in this thread here
Since removing my old bushes (which were stamped BMW) i can confirm they have the same codes and markings, but with the BMW writing and the part code removed.
All parts removed were cleaned, de-greased and painted with Vactan. Rear beam and ARB were overpainted using Frost chassis black, the trailing arms, steel headshields and assorted brackets were left just coated with Vactan. Diff was painted silver, fuel tank after treatment was sprayed with Hammerite stone chip.
If (big if!) i were to do this again and didnt need to access the tank/brake lines i would just lower the beam and re-bush with Poly's, just to make the job easier
Bush removel/insertion tool was home made and worked well.
I would have taken some better pictures of the finished product but i was more interested in getting the car back on the road again!!













