Post
Sun Oct 22, 2006 6:23 am
use a piece of wire to short out pin 7 and 11 at the engine plug (make sure you get it right too) turn on the ignition but dont start with the two pins shorted, wait about 7 seconds the green lights should reset. turn off ignition and repeat and the inspection light will turn off too.
note the older (smaller) plugs the pin numbers are marked in the underneath of the dust cap, they are correct only when the cap is ON THE PLUG, i.e the pin numbers will be wrong if you turn the cap over to look at the numbers.
the newer ones have numbers inside the plug itself and can be seen wioth aid of a torch.
mrlee