I want to remove the heating bit from the inlet manifold. And therefore put a joint in.
Cheers
Diameter of pipes
Moderator: martauto
-
Project_E30
- E30 Zone Camper
- Posts: 1107
- Joined: Thu Jan 13, 2005 11:00 pm
Can anyone tell me the external diameter of the pipes on item 4 below.
I want to remove the heating bit from the inlet manifold. And therefore put a joint in.
Cheers
I want to remove the heating bit from the inlet manifold. And therefore put a joint in.
Cheers
-
E30Mark
- E30 Zone Team Member
- Posts: 8107
- Joined: Sun Jan 09, 2005 11:00 pm
- Location: Wimborne, Dorset
I think you actually want the internal diameter ! my guess is it's about 8mm...
1 & 2 bed flats in Bournemouth areas, with parking
PM for details
PM for details
-
Project_E30
- E30 Zone Camper
- Posts: 1107
- Joined: Thu Jan 13, 2005 11:00 pm
No the external diameter! As I need to know what size tube fits over it. Therefore the external diameter of the pipe will give me the internal diameter of the tube.E30Mark wrote:I think you actually want the internal diameter ! my guess is it's about 8mm...
you can also block that circuit from the source,
i.e put in a bolt in the hoses that are the correct size and thus stoping the circulation,
Or leave it, it has nothing do with performance only helping the throttle body from freezing in cold weather,
i.e put in a bolt in the hoses that are the correct size and thus stoping the circulation,
Or leave it, it has nothing do with performance only helping the throttle body from freezing in cold weather,