Lower control arms...

[Matt_T]

How are you meant to remove the inner balljoint?

[Brianmoooore]

You're not really, but they press out. Or grind the bottom off, knock the ball and pin out, and saw through the side of the bit that's left.

[Matt_T]

Sorry i meant remove the control arm from the subframe, managed to get the nearside off with a socket and breaker but looks like the offside will need a 22mm spanner.

Any tips on removing the bush from the 'lollipop'?

[Chris-W]

Very long extension bar down from the top of the engine compartment to undo the nut on the upper ball-joint.

You can saw through the metal sleeve at the outside of the bush to remove it from the lollipop.

[DanThe]

Half inch drive "wobble" extensions are the tools for this job

[Matt_T]

You can saw through the metal sleeve at the outside of the bush to remove it from the lollipop.

Worked a treat cheers.