So, ive just bought a set, what have people found are good settings? I know i could play about with them, but there is 12 possible combinations, and that'll take a while!
Ideally i think i want to introduce a little more oversteer as my car tends to understeer when pushed.
H&R roll bar adjustment
Moderator: martauto
-
Jamesb318is
- E30 Zone Regular
- Posts: 620
- Joined: Wed Jan 12, 2005 11:00 pm
- Location: East Sussex
- Contact:
Last edited by Jamesb318is on Wed Aug 23, 2006 11:03 pm, edited 1 time in total.
-
aus325
- E30 Zone Newbie
- Posts: 145
- Joined: Sun Mar 13, 2005 11:00 pm
- Location: Hobart, Tasmania, Australia
I have Ireland Engineering 25/22 swaybars on my 325i, and have to run the rear a little soft (mega-scary on any type of stiff setting!!). Fronts are currently set for middle adjustment, and turn-in is fantastic. Be sure to try as much adjustment as you can, the differences may only be subtle, but you will know when it's just right.
I have 35mm cupkit and H+R Roll bars, I run the front on the softest and the rear on the hardest. Handles so well, if you set up for the corner you can take it at very fast speeds.
When I had the front on medium i was getting too much understeer. Could be my style of driving though!!
When I had the front on medium i was getting too much understeer. Could be my style of driving though!!