Rear Seat removal

[Simon325i]

Hi Guys,

Can anyone shed any light on removing the rear seat?

Fronts came out no problem as did the rear bench but could'nt get the seat back to budge at all

Any help appreciated, do know if it makes a difference but its 90 model 4 door with aftermarket leather.

Thanks,
Simon.

[cliffybabe]

right the rear should lift up i think, once there up there a bolt in either corner u remove and the seats are out

Can some one confirm this though as this applies to the 2 door version dont see y it would be any different in a 4 door

[dazleeds]

ok its easy

the bottom part just grab the front edge and pull upwards it will come straight out as it just pops onto 2 metal bits

the back part is held on with 2 10mm screws/bolts 1 behind each rear side panels
undo these then push the whole thing upwards to release it from 2 metal prongs behind it

5 minute job mate

good luck

Daz

[Simon325i]

Cheers for that, got the bottom out ok but it twas the backs that were the bugger.

Looked everywhere for screws/bolts but could'nt find any but knew there must be some as all the pushing, lifting, tugging and swearing did'nt help!

Will have another go tonight.

Cheers,
Simon.

[cliffybabe]

i wanst far off

[dazleeds]

Cheers for that, got the bottom out ok but it twas the backs that were the bugger.

Looked everywhere for screws/bolts but could'nt find any but knew there must be some as all the pushing, lifting, tugging and swearing did'nt help!

Will have another go tonight.

Cheers,
Simon.

just pull the vynal back slightly on the read doorcards bits and youll see a 10mm on each side going thru a small bar that comes from the seat back

youll suss it mate
Daz

[Simon325i]

Cheers Daz, came out quicker than you could spend a tenner in Blue Leopard

[dazleeds]

Cheers Daz, came out quicker than you could spend a tenner in Blue Leopard

happy to help mate

Daz