front valence

[tbmw]

have done a search but cant really find what i need

Whats the easiest way to remove the front valence, have a rieger infinity lip spoiler to fit and wanna remove the valence to bolt it up

Thanks in advance
tony

[Bob_S]

strip off the bumper, then inner arches, and brake duct guides.
strip out the fogs and ducts from the front and the headlight grills. I cant rememeber ecactly where all the bolts are but there arent many and once you start undoing some other will become apparent job can take a short while but do it properly otherwise things will break

also remove the brakcets at the side which hold the ends of the bumper up.

[tbmw]

cheers m8

[Bob_S]

no worries!

[boomer]

Remember the loom that runs across the front of the rad - unclip from holes in shown in photo - hidden behind bumper:



Also bolts/screws under outside headlamps (see above - wing goes over valence at this point)

and a couple of the front upper wing bolts to allow mild bendage.

HTH