Removing front bumber and front wings
Moderator: martauto
-
Nathan
- E30 Zone Newbie
- Posts: 52
- Joined: Sat Apr 16, 2005 11:00 pm
Any pointers on doing this would be greatly appreciated
-
joker
- E30 Zone Newbie
- Posts: 116
- Joined: Wed Mar 23, 2005 11:00 pm
- Location: Braintree, Essex.
I believe you will need a T55 Torx bit (male) for the bumper and wing fixings.
Remove black trim, then bumper fixings and you will then see other wing fixings.
Remove black trim, then bumper fixings and you will then see other wing fixings.
-
Brianmoooore
- E30 Zone Team Member
- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
T55 torx on newer E30s, 10mm (IIRC) female hex on older ones. (Look underneath bumper).
Undo these two bolts and pull bumper straight forwards.
Remove plastic wheel arch liners, and undo every 8mm self tapper you can see. Couple of 10mm screws on the bumper rear mount brackets, and a small countersunk female hex screw each side hidden beneath the headlamp area.
Undo these two bolts and pull bumper straight forwards.
Remove plastic wheel arch liners, and undo every 8mm self tapper you can see. Couple of 10mm screws on the bumper rear mount brackets, and a small countersunk female hex screw each side hidden beneath the headlamp area.