Can you tell from pic whether it will fit.....

Post Thu May 18, 2006 9:09 am

a 2 or 3 piece system on a 325i sport

Thanks in advance i need to know asap!!

NOTE: Pic courtesy of Rosco83

Post Thu May 18, 2006 10:26 am

there should be a second piece with two pipes and a cross flow piece (shaped like an X) going back into two pipes which would then go to your centre box/cat. make sure its for a LeftHandDrive car as a RHD manifold would foul on the power sterring pump and dont think it will fit.

mrlee

Post Thu May 18, 2006 10:56 am

mrLEE30 wrote:there should be a second piece with two pipes and a cross flow piece (shaped like an X) going back into two pipes which would then go to your centre box/cat. make sure its for a LeftHandDrive car as a RHD manifold would foul on the power sterring pump and dont think it will fit.

mrlee

Thanks, So just to clarify these 2 bits are vital piece for both 2 & 3 piece systems?

Currenly I have a standard 2 piece system and was kinda hoping it would just replace the existing manifold.....obviously not that simple!

Post Thu May 18, 2006 11:00 am

hmmm
how come mine dosent have a crossover??

fritzbits manifold

can i get 1 made and fitted in??

sorry ot

Post Thu May 18, 2006 11:27 am

dazleeds wrote:hmmm
how come mine dosent have a crossover??

fritzbits manifold

can i get 1 made and fitted in??

sorry ot

did you have an extra bit of pipework on your fritzbits one?

Post Thu May 18, 2006 11:44 am

IS that for RHD? Looks very tight.

Andrew

Post Thu May 18, 2006 12:28 pm

I dont know, Im sorting a deal on it as we speak, but sounding like more hassle by the minute, so bollox to it I think.

Thanks for your advice/views

Post Thu May 18, 2006 2:03 pm

looks like a gen Alpina unit to my eyes,

LHD alpina @ that from the sweep on the lowers

Post Thu May 18, 2006 2:06 pm

Looks LHD to me too Ant, BTW your bits are about to get sent out!

Andrew