Thanks very much everyone for your nice comments
I have no idea on the wheel offset as i didnt actually quote an offset to image, i just measured between the hubface and the nearest inner and outer points, then used this to make up the final width and offset.
As for price, well they cost the wrong side of a bag of sand including tyres, so not too bad, but not cheap either! (and that was with discount! they gave me 10% off because i said i was a member of a very large BMW forum and go to a few shows a year so could big up their wheels!)
Thanks for the comments on the exhaust Eko, it rattles a bit on the bumper occasionally, so i might have to cut out the bumper a bit more, but it sounds awesome at full chat!
I know i know it needs lowering! Wanna do it properly though, so new springs, dampers, a sump guard, and some arch rolling aint gonna come cheap!! Gonna be a while yet!
Btw the 'M' badge is staying!