Hi, Will the e30 m20 clutch slave cylinder fit the e34 m30 gearbox or will I have to buy a e34 slave?
ED
slave cylinder
Moderator: martauto
-
stevetigger
- E30 Zone Addict
- Posts: 4659
- Joined: Thu Feb 24, 2005 11:00 pm
I dont know the answer but Im sure somebody does!
But Im sure I read on here that you will need the slave from the gearbox your using!
But Im sure I read on here that you will need the slave from the gearbox your using!
-
Brianmoooore
- E30 Zone Team Member
- Posts: 49359
- Joined: Mon Jan 10, 2005 11:00 pm
Posted on this on another thread, two minutes ago!
You need the slave that goes with the gearbox. E30 is far to short. There are photos of the two on the other thread.
You need the slave that goes with the gearbox. E30 is far to short. There are photos of the two on the other thread.
-
Brianmoooore
- E30 Zone Team Member
- Posts: 49359
- Joined: Mon Jan 10, 2005 11:00 pm
Thread is "M50 developments"
-
ed325i
- E30 Zone Addict
- Posts: 4146
- Joined: Mon Jan 10, 2005 11:00 pm
Found the thread thanks Brian
ED
ED
-
DanThe
- E30 Zone Team Member
- Posts: 28646
- Joined: Sat Sep 10, 2005 11:00 pm
- Location: Staffs
Just to confuse matters, I have used the slave from a 318 E36 on a 316 E30 before. And the clutch master cylinder innards can be put into the E30 master
Infact, im pretty sure all the E30's use the same slave cylinder
Infact, im pretty sure all the E30's use the same slave cylinder