Is this Normal? can i just screw it all the way in to let the pedal go asfar as possible?
throttle stop behind pedal
Moderator: martauto
-
appletree
- E30 Zone Addict
- Posts: 3479
- Joined: Fri Jan 20, 2006 11:00 pm
- Location: Retford
Just been cleaning out the foot well on the IS and noticed theres a bolt that sits against the back of the pedal when its to the boards, the bolt can be screwed in and out.
Is this Normal? can i just screw it all the way in to let the pedal go asfar as possible?
Is this Normal? can i just screw it all the way in to let the pedal go asfar as possible?
-
Brianmoooore
- E30 Zone Team Member
- Posts: 49360
- Joined: Mon Jan 10, 2005 11:00 pm
If you want to wreck your throttle cable and linkage, then go ahead.
Throttle cable should be adjusted for a tiny bit of slack in the cable when fully closed, then the bolt in question is adjusted so that with the pedal fully down, the throttle butterfly is just short of fully open.
Throttle cable should be adjusted for a tiny bit of slack in the cable when fully closed, then the bolt in question is adjusted so that with the pedal fully down, the throttle butterfly is just short of fully open.
-
appletree
- E30 Zone Addict
- Posts: 3479
- Joined: Fri Jan 20, 2006 11:00 pm
- Location: Retford
cheers, i haven't played with it atall as i thought it might do somthing like that thats why i asked on here first, i thougt it would either open the butterfly more or just pull i to far round and start to close it again, good job i asked! 
cheers
cheers