Removing mtec 1 rear bumper - help???

[nasir325ic]

Can any one tell me how to remove the rear mtec 1 bumper, Ive taken the 4 bolts of near the wheel arch, and the four in the boot, two of which are on the rear and one on each side.

But the damn thing seems like its stuck some where. And yeah ive taken off the bracket from underneath near the exhaust?

Some one please help me b4 i rip the bastard thing off with a crow bar

[Theo]

Have you undone the self tapping screws which are accessible from the boot and screw into the rubber bumper ends? There should be two brakets underneath the metal bumper which need undoing, (you only mentioned one) Think this is all that is needed, then you sort of have to negotiaite it of pulling it away from the car so to speak.

[nasir325ic]

in total from inside the boot i have removed 4 nuts, do i need to get under neath the car? because its the mtech bumper its quite difficult to access.

[Theo]

When you go underneath to remove it, dont take the bumper of the bracket, take the bracket of the car with bumper still attached, any help? It really not good that i cant remember better how to do it, was only about 2 1/2 months ago I was doing the same!