Have i got the right scorpion exhaust??

Need technical Q/A then you're in the right place

Moderator: martauto

wilkos
E30 Zone Newbie
E30 Zone Newbie
Posts: 115
Joined: Thu Feb 17, 2005 11:00 pm
Location: Staffordshire

Post Thu Mar 02, 2006 6:41 pm

Got home tonight and found my Scorpion system waiting for me :D so I opened it up and found it to be a three piece system and the original system on my '91 sport is a two piece!,which i told them over the phone when i ordered it!!
Basically is this right do they come as a three piece for the later sports or have i been sent the wrong exhaust? :cry: I'd be grateful if someone out there can put me right, before i phone them up and give 'em a round of fcuk's :x cheers. Si
Simon13
The longest resto in the world !
Posts: 22697
Joined: Mon Jan 10, 2005 11:00 pm
Location: Camberley, Surrey don't u know

Post Thu Mar 02, 2006 6:52 pm

no it's fine, 3 piece and 2 piece fit on 325i's. No problems my man!
wilkos
E30 Zone Newbie
E30 Zone Newbie
Posts: 115
Joined: Thu Feb 17, 2005 11:00 pm
Location: Staffordshire

Post Thu Mar 02, 2006 8:47 pm

Cheers for that dude so should have no probs even tho the old system was a two piece will the mounts be in the right place etc?
kam-325i
E30 Zone Team Member
E30 Zone Team Member
Posts: 4851
Joined: Tue Sep 27, 2005 11:00 pm
Location: TELFORD !!!! (Shropshire) Stevetigger Land !!!

Post Thu Mar 02, 2006 9:00 pm

The mounts should be in the same place...

One just before the front box

One just before the Rear beam

Two for the back box
Pete don't care about colour, He would shag a rainbow if he could find the end of it....
Image
oze30
E30 Zone Addict
E30 Zone Addict
Posts: 4133
Joined: Mon Oct 24, 2005 11:00 pm
Location: Sydney

Post Fri Mar 03, 2006 4:30 pm

erm.. slight problem.. You're going to have to go to a exhaust shop and cut the rear of the two piece in order to fit the 3 piece rear. The 2 piece is rear box and pipes to a fl;ange just after the middle box... the front section is from the downpipes back to the middle box, then the flange.

You'll need to have a looksie to see if this is possible, else.. i dunno what to do!

HTH