M20 Stroker Bits

[clarko74]

I once had a plan to build a 2.8 M20, but have since gone down the M54 route. I had gathered a few parts for the M20 build which have just been sitting around in my house for the past few years, so it's about time a got rid of them.

So, I have an M52B28 crank, I think this is the TU one, it's the one that works without any issues anyway. £150 collected from New Ash Green in Kent (very close to Brands Hatch), I would much prefer collection of this but I could send it if necessary and can get a quote.

I also have an M20B20 block, it's in good condition, it's under a load of stuff at the moment but I'll dig it out shortly. I think it has the crank in it still but no con rods or pistons. The hub bolt has been removed. £60 collected. I'd like to send this even less than the crank so I'll say collection only as I don't have a pallet to strap it to for postage.

I have a few other M20 parts (AFM, throttle body, new gaskets/bolts etc.) which I will list in a separate post when I have photographed them.

A couple of photos:

2023-12-06 21.27.06 (Large).jpg

I'll get come better pics of this soon:

2023-12-06 21.36.49 (Large).jpg

Cheers

[clarko74]

Another photo of the block:

20231211_135254.jpg

I also found these, A set of M20B20 130mm Conrods, £40 plus postage:

20231211_134802.jpg

[twenty]

Hi,
Is the crank still for sale?
Thanks.

[clarko74]

It is yes.

[linke30]

Hi, is the crank and rods still available ?

[clarko74]

Yeah, I still have these.

[linke30]

I’ve sent you a pm

[clarko74]

Crank and rods are now sold.

The block is still available.