Front drivers side CAB wing.

[ah]

As above.

[Dlb26]

There's one on Ebay now, hope you have deep pockets.
https://www.ebay.co.uk/itm/193704370138

[ah]

Yes that would be perfect if I had £275 laying around, as my car Is bleeding me dry lately.

[Dlb26]

The other option is to weld the extra section to the bottom of an existing or pattern wing from a saloon or touring.
Check out Valcas garage, they sell the piece ready made although I fabricated mine from scratch as I was unaware of these at the time.
Beware if you use pattern, it will need adjusting pretty much everywhere to fit anything like.

[Satan]

The other option is to weld the extra section to the bottom of an existing or pattern wing from a saloon or touring.
Check out Valcas garage, they sell the piece ready made although I fabricated mine from scratch as I was unaware of these at the time.
Beware if you use pattern, it will need adjusting pretty much everywhere to fit anything like.

Reminds me I need to get my wings sorted out and did buy the bottom sections form Valca's garage.

[ah]

The other option is to weld the extra section to the bottom of an existing or pattern wing from a saloon or touring.
Check out Valcas garage, they sell the piece ready made although I fabricated mine from scratch as I was unaware of these at the time.
Beware if you use pattern, it will need adjusting pretty much everywhere to fit anything like.

That’s handy to know,as I’m a welder fabricator by trade should be ok to do.

[Dlb26]

There you go then, no problems for you. I fabbed from zintec steel and got one of the welders at work to do the honours. We positioned the weld under where the lowed trim sits.