Adjusting Ride Height

[ozzy2006]

Hi Peeps

I have a 91 cabby which I fitted a H&R cup kit 60/40 suspension set on it with 16" x 9 all round...I also have a tech 2 kit ..

My problem is that when the lower valance is put on there is literally only a finger space between the ground and the valance.

Is there something i can do the raise the ride height on the front slightly so it's not so slammed ...without changing the suspension set up...

Thanks

Ozzy

[steve_k]

you could always try a set of these \/\/\/\/\/

http://www.springassisters.co.uk/menu.htm

easy enough to remove if needed.

[Brianmoooore]

Higher profile tyres.

[ozzy2006]

Higher profile tyres.

That could defo help with some height ...might still need other methods...good shout though

[ozzy2006]

you could always try a set of these \/\/\/\/\/

http://www.springassisters.co.uk/menu.htm

easy enough to remove if needed.

Will look into it...see how it might work with my existing set up..

Thanks

Ozzy

[ozzy2006]

you could always try a set of these \/\/\/\/\/

http://www.springassisters.co.uk/menu.htm

easy enough to remove if needed.

Will look into it...see how it might work with my existing set up..

Thanks

Ozzy

I have looked into these ..I don't see how they would help...or maybe I'm just a bit thick....

[ozzy2006]

The front is a 60mm drop...should I maybe swap out the springs...and would any make of spring work with the shock...or try to get another H&R spring..which from quick reading only do a 30mm variant for the convertible...will that be low enough...