MTech 2 body kit

[alexbaby88]

I'm after the part numbers for the clips that attach the front and rear bumpers to the car body.

Can anyone help?

[bigun]

i dont know the part numbers off hand but you will only need them for the front bottom valance as the rear is all in one try realoem.com

[mrLEE30]

mate rear held on by the standard bumper mounts and lower valance is part of the bumper.

front bumper is held on by the original bumper mounts but the valance requires some drilling and additional clips. if you pm me with your email address i will send you a tech article i am writing (but not yet submitted) on fitting these tech 2 bumpers.

FYI go to here

http://www.realoem.com/bmw/showparts.do ... g=51&fg=15

and you need 5 Nos of part No. 3 (clamp)

6Nos of part no 4 (but these can be found in any car accessories shop)

and parts 5,6,7 are to hold the sides to the car but only if the tech 2 lower valance has the retaining plastic bit to hold part 5, ,most break off when they are removed, i fitted mine and used black silicone instead of these parts.

note also that the brake air ducts are no the same aa standard so make sure you get those too.

mrlee

[alexbaby88]

Great stuff, sending you PM.

Thanks