Gearbox mounts and crossmember

[steve_k]

Afternoon folks.

Looking for some advice.

In the process of changing the gearbox mounts & I've hit a problem.

Changed the mounts, Got them all good & tight but here's the problem.

Got the G/box held up by the jack. But when I came to tighten up the nuts that hold the crossmember in place the two "captive" bolts that sit in a channel either side just spin in the channel.

I can get the nuts on a fee threads but then the bolts start spinning & won't tighten up.
Would a screwdriver behind them in the channel work to hold them in place??

Thanks in advance.

[Cloggy Saint]

Would a screwdriver behind them in the channel work to hold them in place??

Have you tried this?

[steve_k]

Would a screwdriver behind them in the channel work to hold them in place??

Have you tried this?

Going to soon, fingers crossed

[steve_k]

tried it, worked a treat job done